Container Substation: Safe Reliable Compact
Container Substation: Safe Reliable Compact
Container Substation: Safe Reliable Compact
SUBSTATION
Safe Reliable Compact
GENERAL
There are basically three types of prefabricated substations:
1. Mobile standard container substation
2. Fixed type standard container substation
3. Non-standard switch-room or power control room
QUALITY
• TAMCO operates a Quality System in line with ISO9001 and ISO14001
• In addition to in-house routine and QC test, all switchgear products are
fully type tested and certified by CESI/KEMA.
6.6 – 40.5kV GIS RATINGS • Shortening site installation and commissioning time
Rated short circuit 25kA 31.5kA
Rated Current 1250 – 2500A 1250 – 2500A
Battery and charger for DC Ready-to-use LV and MV substations Arc barriers or arc gas duct for MV AIS
control of LV and MV switchgear Walk-in type containers with TAMCO compact and GIS
Normal air conditioning and proven AIS & GIS Container pressure relief flap
Wall mounted fire extinguishers Easy to transport using a standard container truck Heating and Ventilation System (HVAC)
are provided as standard or a towing trailer
Automatic smoke and heat detection alarm
Lightings and power sockets Approved for transportation on land and sea system and automatic shut down and gas
Minimum levelling is required for the concrete suppression fire fighting system
base that supports the total weight
Shock proof spring loaded connection
Large cost saving since construction of substation fluorescent lamps
is not required
Switch-room structure designed to
Customized LV and MV Switchgear layout for withstand severe seismic and cyclone
each type of application conditions using computer simulation
Fully assembled and tested in TAMCO factory method
All control and protection interfacing wiring are Steel foundation base for fixed container
done in TAMCO or switch-room type substations
SCADA system interfacing marshalling kiosks are Stainless Steel landing platforms
available on request
Control and relay panels or remote panels can be
supplied
Plug-in power cables and drawout VT are used for
MV GIS
The information contained herein is correct at time of printing, but as the products and its manufacturing processes are being developed continuously, this information is subject to change without notice, and
the company cannot be held liable for any alleged misinterpretation howsoever arising.