Uee Types of Tariff (Yash Jadhao)

Government Polytechnic,Washim
A
MICRO PROJECT REPORT
ON
“TYPES OF TARIFFS”
Submitted By
Yash Rajesh Jadhao
Roll no. 19
Enrollment no. 1800310095
(Third Year Diploma in Electrical Engineering)
Guided By H.O.D
Mr. P. M. Lonarkar Mr . R. W. Patil
(Electrical Department) (Electrical Department)
Principal
Dr. V. R. Mankar
( Government Polytechnic, Washim)
DEPARTMENT OF ELECTRICAL ENGINEERING
2021 – 2022
ELECTRICITY TARIFFS
INTRODUCTION
The amount of money frame by the supplier for the supply of electrical
energy to various types of consumers in known as an electricity tariff. In
other words, the tariff is the methods of charging a consumer for consuming
electric power. The tariff covers the total cost of producing and supplying
electric energy plus a reasonable cost.
The actual tariffs that the customer pay depends on the consumption of the
electricity. The consumer bill varies according to their requirements. The
industrial consumers pay more tariffs because they use more power for long
times than the domestic consumers.
The electricity tariffs depends on the following factors
 Type of load
 Time at which load is required.
 The power factor of the load.
 The amount of energy used.
The total bill of the consumer has three parts, namely, fixed charge D, semi-
fixed charge Ax and running charge By.
where, C – total charge for a period (say one month)

x – maximum demand during the period (kW or kVA)
y – Total energy consumed during te period (kW or kVA)
A – cost per kW or kVa of maximum demand.
B – cost per kWh of energy consumed.
D – fixed charge during each billing period.
This is known as three-part electricity tariff, and it is mainly applied to the

big consumer.
YASH JADHAO
Factors Affecting the Electricity Tariffs
The following factors are taken into accounts to decide the electricity tariff:
 Types of Load – The load is mainly classified into three types, i.e.,
domestic, commercial, or industrial. The industrial consumers use
more energy for a longer time than domestic consumers, and hence
the tariff for the industrial consumers is more than the domestic
consumers. The tariff of the electric energy varies according to
their requirement.
 Maximum demand – The cost of the electrical energy supplied by
a generating station depends on the installed capacity of the plant
and kWh generated. Increased in maximum capacity increased the
installed capacity of the generating station.
 The time at which load is required – The time at which the
maximum load required is also essential for the electricity tariff. If
the maximum demand coincides with the maximum demand of the
consumer, then the additional plant is required. And if the
maximum demand of the consumers occurs during off-peak hours,
the load factor is improved, and no extra plant capacity is needed.
Thus, the overall cost per kWh generated is reduced.
 The power factor of the load – The power factor plays a major
role in the plant economics. The low power factor increases the
load current which increases the losses in the system. Thus, the
regulation becomes poor. For improving the power factor, the
power factor correction equipment is installed at the generating
station. Thus, the cost of the generation increases.
 The amount of energy used – The cost of electrical energy is
reduced by using large amounts of energy for longer periods.
YASH JADHAO
Types of Electricity Tariff
Some of the most important types of tariff are as follows;
1. Flat Demand Rate tariff

2. Straight-line Meter rate tariff
3. Block meter Rate tariff
4. Two-part tariff
5. Power factor tariff
6. Seasonal rate tariff
7. Peak load tariff
8. Three-part tariff
The different types of tariffs are explained below in details
1. Flat demand rate tariff – The flat demand rate tariff is expressed by the
equation C = Ax. In this type of tariff, the bill of the power consumption
depends only on the maximum demand of the load. The generation of the bill
is independent of the normal energy consumption. This type of tariff is used
on the street light, sign lighting, irrigation, etc., where the working hours of
the equipment are unknown. The metering system is not used for calculating
such type of tariffs.
2. Straight-line meter rate tariff – This type of tariff is given by the

equation C = By. The generation of the bills depends on the energy
consumption of the load. Thus, different types of bills are generated by the
consumers.
The charges for different types of consumption depends on the load and
diversity factors of the load. For example, the tariff for small devices is less
as compared to the power loads. Hence different meters are used for
measuring the power consumption
YASH JADHAO
3. Block meter rate tariff – In this type of tariff, the energy consumption is
distinguished into blocks. The per unit tariff of the individual block is fixed.
The price of the block is arranged in the decreasing order. The first block has
the highest cost, and it goes on decreasing accordingly.
The price and the energy consumption are divided into three blocks. The first
few units of energy at a certain rate, the next at a slightly lower rate and the
remaining unit at a very lower rate.
4. Two-part tariff – In such type of tariff, the total bill is divided into two
parts. The first one is the fixed charge and the second is the running charge.
The fixed charge is because of the maximum demand and the second charge
depends on the energy consumption by the load.
The factor A and B may be constant and vary according to some sliding.
YASH JADHAO
5. Power factor tariff – The tariff, which depends on the power factor of the
load, is known as the power factor tariff. The power factor tariff is mainly
classified into two types.
a. kVA maximum demand tariff – This is also a two-part tariff.
The low power factor increases the KVA

rating of the load.
b. kWh and kVarh tariff – The bill is calculated by the sum of the kVarh
and Kwh rating of the load
The kVarh is inversely proportional to the power factor of the load.
c. Sliding Scale or Average power factor tariff – In Average power factor

tariff, the particular value of the power factor is taken as reference. If the
power factor at the consumer end is low, then the consumer has to pay the
additional charges. Similarly, if the power factor of the load is above from the
reference value, then the discount will be given to the consumer.
6. Seasonal rate tariff – Such type of tariff measures the high price in kWh
used by the consumer in one complete year. It is also known as the on peak
season tariff. If the low consumption occurs in the year, then it called the off-
peak season tariffs.
7. Peak-load tariff – Such type of tariff is similar to peak load tariffs. The

only difference is that the seasonal tariff measures the peak hour of the year
and the peak tariff calculates it for the day. If the power consumption is high,
then it is known as the on-peak tariff, and for low power consumption, it is
called off-peak load tariffs.
The peak load and seasonal tariffs both are used for reducing the idle or
standby capacity of the load.
8. Three-part tariff – The three-part tariff is in the form of,

and it is applied to the big consumer.
YASH JADHAO

Uee Types of Tariff (Yash Jadhao)

Uploaded by

Copyright:

Available Formats

Uee Types of Tariff (Yash Jadhao)

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Uee Types of Tariff (Yash Jadhao)

Uploaded by

Copyright:

Available Formats

Government Polytechnic,Washim

(Third Year Diploma in Electrical Engineering)

DEPARTMENT OF ELECTRICAL ENGINEERING

The electricity tariffs depends on the following factors

where, C – total charge for a period (say one month)

This is known as three-part electricity tariff, and it is mainly applied to the

1. Flat Demand Rate tariff

2. Straight-line meter rate tariff – This type of tariff is given by the

a. kVA maximum demand tariff – This is also a two-part tariff.

The low power factor increases the KVA

The kVarh is inversely proportional to the power factor of the load.

c. Sliding Scale or Average power factor tariff – In Average power factor

7. Peak-load tariff – Such type of tariff is similar to peak load tariffs. The

8. Three-part tariff – The three-part tariff is in the form of,

You might also like