Cisco Networking Academy http://assessment.netacad.net/virtuoso/delivery/pub-doc/exam.

shtml

Assessment System
Skip to Time Left | Skip to Navigation | Skip to Assessment Items

Take Assessment - ESwitching Chapter 5 - CCNA Exploration: LAN Switching and

Time Remaining: 01:59:59

Showing 1 of 2 Next> Page: GO <Prev

1 What two elements will exist in a converged network with one spanning tree? (Choose two.)
one root bridge per network
all non-designated ports forwarding
one root port per non-root bridge
multiple designated ports per segment
one designated port per network

2 Which two criteria does a switch use to select the root bridge? (Choose two.)
bridge priority
switching speed
number of ports
base MAC address
switch location
memory size

Refer to the exhibit. The spanning-tree port priority of each interface is at the default setting. The
network administrator enters the spanning-tree vlan 1 root primary command on S4. What is the

1 of 4 9/5/2010 11:04 AM
Cisco Networking Academy http://assessment.netacad.net/virtuoso/delivery/pub-doc/exam.shtml

effect of the command?

4 In which two ways is the information that is contained in BPDUs used by switches? (Choose two.)
to negotiate a trunk between switches
to set the duplex mode of a redundant link
to identify the shortest path to the root bridge
to prevent loops by sharing bridging tables between connected switches
to determine which ports will forward frames as part of the spanning tree

5 Which two actions does an RSTP edge port take if it receives a BPDU? (Choose two.)
immediately loses its edge status
inhibits the generation of a TCN
goes immediately to a learning state
disables itself
becomes a normal spanning-tree port

6 How can a network administrator influence which STP switch becomes the root bridge?
Configure all the interfaces on the switch as the static root ports.
Change the BPDU to a lower value than that of the other switches in the network.
Assign a lower IP address to the switch than that of the other switches in the network.
Set the switch priority to a smaller value than that of the other switches in the network.

7 What Rapid Spanning Tree Protocol (RSTP) role is assigned to the forwarding port elected for every
Ethernet LAN segment that links two switches?
alternate
backup
designated
edge

8 Which two items are true regarding the spanning-tree portfast command? (Choose two.)
PortFast is Cisco proprietary.
PortFast can negatively effect DHCP services.
PortFast is used to more quickly prevent and eliminate bridging loops.
Enabling PortFast on trunks that connect to other switches improves convergence.
If an access port is configured with PortFast, it immediately transitions from a blocking to a
forwarding state.

2 of 4 9/5/2010 11:04 AM
Cisco Networking Academy http://assessment.netacad.net/virtuoso/delivery/pub-doc/exam.shtml

Refer to the exhibit. All switches in the network have empty MAC tables. STP has been disabled on
the switches in the network. How will a broadcast frame that is sent by host PC1 be handled on the
network?
Switch SW1 will block the broadcast and drop the frame.
Switch SW1 will forward the broadcast out all switch ports, except the originating port. This will
generate an endless loop in the network.
Switch SW1 will forward the broadcast out all switch ports, except the originating port. All hosts in
the network will reply with a unicast frame sent to host PC1.
Switch SW1 will forward the traffic out all switch ports except the originating port as a unicast
frame. All hosts in the network will reply with a unicast frame sent to switch SW1.

10 Which two statements describe the BIDs used in a spanning tree topology? (Choose two.)
They are sent out by the root bridge only after the inferior BPDUs are sent.
They consist of a bridge priority and MAC address.
Only the root bridge will send out a BID.
They are used by the switches in a spanning tree topology to elect the root bridge.
The switch with the fastest processor will have the lowest BID.

11 What is the first step in the process of convergence in a spanning tree topology?
election of the root bridge
blocking of the non-designated ports
selection of the designated trunk port
determination of the designated port for each segment

12 Which two statements are true about the default operation of STP in a Layer 2 switched environment
that has redundant connections between switches? (Choose two.)
The root switch is the switch with the highest speed ports.
Decisions on which port to block when two ports have equal cost depend on the port priority and
identity.
All trunking ports are designated and not blocked.
Root switches have all ports set as root ports.
Non-root switches each have only one root port.

13 Which three statements are accurate regarding RSTP and STP? (Choose three.)
RSTP uses a faster algorithm to determine root ports.

3 of 4 9/5/2010 11:04 AM
Cisco Networking Academy http://assessment.netacad.net/virtuoso/delivery/pub-doc/exam.shtml

RSTP introduced the extended system ID to allow for more than 4096 VLANs.
Both RSTP and STP use the portfast command to allow ports to immediately transition to
forwarding state.
Like STP PortFast, an RSTP edge port that receives a BPDU loses its edge port status
immediately and becomes a normal spanning-tree port.
Configuration commands to establish primary and secondary root bridges are identical for STP
and RSTP.
Because of the format of the BPDU packet, RSTP is backward compatible with STP.

14 What two features of the Spanning-Tree Protocol contribute to the time it takes for a switched
network to converge after a topology change occurs? (Choose two.)
the max-age timer
the spanning-tree hold down timer
the forward delay
the spanning-tree path cost
the blocking delay

15

Refer to the exhibit. What can be determined from the output shown?
Two hosts communicating between ports Fa0/2 and Fa0/4 have a cost of 38.
The priority was statically configured to identify the root.
STP is disabled on this switch.
The timers have been altered to reduce convergence time.

Showing 1 of 2 Next> Page: GO <Prev

All contents copyright 1992-2010 Cisco Systems, Inc. Privacy Statement and Trademarks

4 of 4 9/5/2010 11:04 AM