500ma Low Dropout Positive Voltage Regulator: Features General Description
500ma Low Dropout Positive Voltage Regulator: Features General Description
500ma Low Dropout Positive Voltage Regulator: Features General Description
Marking Information
GND VOUT GND VIN
For marking information, contact our sales representative (TAB) (TAB)
VOUT VIN
directly or through a Richtek distributor located in your SOT-223 (Type-I)
area. TO-252
1 2 3 1 2 3 1 2 3
RT9163
VIN VIN VOUT VOUT
+
+
CIN GND COUT
10uF 10uF
Buffer
Amplifier
Thermal Q1
Shutdown
R4
Error Current
Amplifier Limiting R3
Sensor
+
- VOUT
R1
VREF
R2
Electrical Characteristics
(VIN = 5V, TA = 25° C, unless otherwise specified)
Note 1. θJA is measured in the natural convection at TA = 25°C on a low effective thermal conductivity test board of
JEDEC 51-3 thermal measurement standard. The case point of θJC is on the center of the exposed pad.
Note 2. Low duty cycle pulse tested with Kelvin connections.
Note 3. The dropout voltage is defined as VIN -VOUT, which is measured when VOUT is VOUT(NORMAL) − 100mV.
Note 4. Bandwidth of 10 Hz to 10 kHz.
D A
b C
e
D1
A1
D
D1 A
B
C
C1
e e
H
b b
b1
D U
C
D1 R
B
T
V
S
E
L1
L3
b1 L2
b e
b2
Information that is provided by Richtek Technology Corporation is believed to be accurate and reliable. Richtek reserves the right to make any change in circuit
design, specification or other related things if necessary without notice at any time. No third party intellectual property infringement of the applications should be
guaranteed by users when integrating Richtek products into any application. No legal responsibility for any said applications is assumed by Richtek.