Titration Virtual Lab

Student Exploration: Titration
Vocabulary: acid, analyte, base, dissociate, equivalence point, indicator, litmus paper, molarity,
neutralize, pH, strong acid, strong base, titrant, titration, titration curve, weak acid, weak base
Prior Knowledge Questions (Do these BEFORE using the Gizmo.)

There are several definitions of acids and bases. According to the
Brønsted-Lowry definition, an acid is a substance that is capable of
donating a proton to another substance. A base is a substance that
accepts protons. When an acid and a base are combined, the acid is
neutralized as the base accepts the protons produced by the acid.
One way to determine if a solution is acidic or basic is to use litmus paper, as shown above.
There are two types of litmus papers: red and blue.
1. How does litmus paper indicate an acid? [ turn pink ]
2. How does litmus paper indicate a neutral substance? [ stays clear ]
3. How does litmus paper indicate a base? [ turn blue ]
Gizmo Warm-up
Litmus is an example of an indicator, a substance that changes
color depending on its pH (pH is a measure of the concentration of
protons, or H+ ions). In the Titration Gizmo™, you will use indicators
to show how acids are neutralized by bases, and vice versa.
To begin, check that 1.00 M NaOH is selected for the Burette,

Mystery HBr is selected for the Flask, and Bromthymol blue is
selected for the Indicator.
1. Look at the flask. What is the color of the bromthymol blue indicator? [ yellow ]
2. What does this tell you about the pH of the solution in the flask? [ slightly acidic ]
Hint: Solutions with a pH below 7.0 are acidic, while those with a pH above 7.0 are basic.
3. Move the slider on the burette to the top to add about 25 mL of NaOH to the flask. What
happens, and what does this tell you about the pH of the flask? [ The color is becoming
darker, the pH is increasing ]
Get the Gizmo ready:

Activity A: ● Click Reset. Select 1.0 M HNO3 for the Burette
and Mystery NaOH for the Flask.
Acids and
● Select Phenolphthalein for the Indicator.
bases ● You will need a scientific calculator for this
activity.
Introduction: When most acids dissolve in water, they dissociate into ions. For example, nitric
3–
acid (HNO3) dissociates into H+ and NO ions.
Question: How do acids and bases interact in solution?
1. Calculate: Concentration is measured by molarity (M), or moles per liter. Brackets are also
used to symbolize molarity. For example, if 0.6 moles of HNO3 are dissolved in a liter of
water, you would say [HNO3] = 0.6 M.
A. Because HNO3 is a strong acid, it dissociates almost completely in water. That

means the concentration of H+ is very nearly equal to that of HNO3.
What is [H+] if [HNO3] is 0.01 M? [ .01 ]
B. The pH of a solution is equal to the negative log of H+ concentration: pH = –log[H+]
What is the pH of this solution? (Use the “log” button on your calculator.) [ 2 ]
C. What is the pH of a 0.6 M HNO3 solution? [ .2 ]
2. Describe: The equation for the reaction of nitric acid (HNO3) and sodium hydroxide (NaOH)
is shown on the bottom right of the Gizmo.
A. What are the reactants in this reaction? [ HNO3 and NaOH ]
B. What are the products of this reaction? [ NaNO3 and H2O ]
3. Measure: A titration can be used to determine the concentration of an acid or base by

measuring the amount of a solution with a known concentration, called the titrant, which
reacts completely with a solution of unknown concentration, called the analyte. The point at
which this occurs is called the equivalence point.
Carefully add HNO3 into the flask until the phenolphthalein begins to lose its color. Stop
adding HNO3 when the color change is permanent.
A. How much (HNO3) was required to cause the indicator to change color? [ 8.9mL ]
B. What can you say about the pH before and after the last drop of HNO3 was added? [ pH was
acidic up to that point ]
4. Explore: Click Reset and change the indicator to Bromthymol blue. Add exactly 8.8 mL of
HNO3 to the flask.
A. What does the color of the indicator tell you about the current pH of the flask? [ The pH is under 6
]
B. Add one more drop of HNO3. What does the color tell you about the pH now? [ The pH is
continuing to fall ]
C. If you combine the results of this question with the results from question 3B, what do
you know about the total pH change caused by adding the last 0.1 mL of HNO3?
[ It will turn acidic ]
5. Apply: Water has a pH of 7. If 0.1 mL (about one drop) of 1.0 M HNO3 is added to 100 mL of
water, the result is a solution with a concentration of 0.001 M HNO3.
A. What is the pH of 0.001 M HNO3? [ 4 ]
B. How much did one drop of HNO3 cause the pH of water to change? [ Not a lot ]
C. How does this relate to what you determined in question 4C? [ Acidic substance can change
bases very quick;y at low concentration ]
6. Explain: A titration curve is a graph of pH vs. volume of titrant.

The graph at below shows a typical titration curve for the titration of a strong acid by a strong base. (A
strong base is one that has relatively high dissociation in water.)
Volume titrant (mL)

A. How would you describe the shape of the titration curve? [ An s ]
B. Why do you think the titration curve has the shape it has? [ Since the pH increase and decreases
with the volume of the titrant and is has a point which reacher equilibrium ]
Get the Gizmo ready:

Activity C:
● Click Reset.
Weak acids
and bases ● Select 1.00 M NaOH for the Burette and
Mystery CH3COOH for the Flask.
Introduction: Unlike strong acids and bases, weak acids and weak bases dissociate relatively
little in water. Some ions are formed, but the remaining molecules remain whole. As a result, the
pH of a weak acid or base is closer to neutral than the pH of a strong acid or base.
When weak acids or bases react with strong bases or acids, the resulting salts often act as
bases or acids themselves, causing the pH at the equivalence point to vary from 7.0. This can
impact your choice of indicator.
Question: What happens when weak acids and bases are titrated?
Gather data: For each indicator given in the Gizmo, what is the pH range over which it
changes color?
Bromthymol blue: [ 6-7.6 pH ] Methyl orange: [ 3.1-4.4 pH ]

Phenolphthalein: [ 8.2-10.0 ]
Interpret: The salt produced by the reaction of acetic acid and sodium hydroxide,
CH3COONa, is a weak base. As a result, the pH of the equivalence point is slightly basic.
The titration curve for this reaction is shown below:
Volume NaOH
A. Why is methyl orange not a good indicator to use for this titration? [ Methyl is an indicator with a
pH range of 3.1-4.4, and the pH is above 7.0 ]
B. What would be a better indicator to use, and why? [ Bromthymol blue because it has a pH
indicator of 6-7.6 so it would be perfect ]
Answer the 5 Assessment Questions under the simulation and take a screenshot of
your score. Note: Only your 1st assessment attempt counts...so make it a good one!!

Titration Virtual Lab

Uploaded by

Copyright:

Available Formats

Titration Virtual Lab

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Titration Virtual Lab

Uploaded by

Copyright:

Available Formats

Student Exploration: Titration

Prior Knowledge Questions (Do these BEFORE using the Gizmo.)

1. How does litmus paper indicate an acid? [ turn pink ]

2. How does litmus paper indicate a neutral substance? [ stays clear ]

3. How does litmus paper indicate a base? [ turn blue ]

To begin, check that 1.00 M NaOH is selected for the Burette,

Get the Gizmo ready:

Question: How do acids and bases interact in solution?

A. Because HNO3 is a strong acid, it dissociates almost completely in water. That

What is [H+] if [HNO3] is 0.01 M? [ .01 ]

B. The pH of a solution is equal to the negative log of H+ concentration: pH = –log[H+]

C. What is the pH of a 0.6 M HNO3 solution? [ .2 ]

A. What are the reactants in this reaction? [ HNO3 and NaOH ]

B. What are the products of this reaction? [ NaNO3 and H2O ]

3. Measure: A titration can be used to determine the concentration of an acid or base by

A. What is the pH of 0.001 M HNO3? [ 4 ]

6. Explain: A titration curve is a graph of pH vs. volume of titrant.

Volume titrant (mL)

Get the Gizmo ready:

Bromthymol blue: [ 6-7.6 pH ] Methyl orange: [ 3.1-4.4 pH ]

You might also like