Scribd
Upload
84 views2 pages

Commissioning With Startdrive - User Interface - Control Panel

The control panel is used to control and monitor individual drives. It contains buttons to activate/deactivate the master control, switch power on/off, enable/disable drives, select operating modes, and control the drive. The display shows actual values and drive status. The control panel layout contains these components and may vary slightly depending on the drive model. Further information can be found in the chapter on using the control panel.

Uploaded by

BALDEV SINGH
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
84 views2 pages

Commissioning With Startdrive - User Interface - Control Panel

The control panel is used to control and monitor individual drives. It contains buttons to activate/deactivate the master control, switch power on/off, enable/disable drives, select operating modes, and control the drive. The display shows actual values and drive status. The control panel layout contains these components and may vary slightly depending on the drive model. Further information can be found in the chapter on using the control panel.

Uploaded by

BALDEV SINGH
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Commissioning with Startdrive

User interface - Control panel

User interface - Control panel

Overview
The control panel is used for the control and monitoring of individual drives. You traverse drives from
the control panel by specifying values (e.g. speed setpoint).

Layout of the control panel


The following figure shows as example the various components of the control panel:

① Activate/deactivate master control


② Switch-on/switch-off infeed
③ Set/reset drive enable signals
④ Select operating mode
⑤ Control drive (elements vary slightly depending on the set operating mode.)
⑥ Display of the actual values
⑦ Indication of the drive status
Figure 1 Example: CU320-2 PN

Restrictions
• The "Switch-on/switch-off infeed" ② option is only available when using a CU320-2 PN without a PM240-2
Power Module.

Further information
You can find further information in Chapter "Using the control panel".

This document constitutes a free excerpt compiled by the user himself/herself from the documentation provided by Siemens for this product. Siemens disclaims all liability for the
completeness of this document. It shall only be used for the user's own internal purposes. It shall not be passed on to third parties.
8/23/2020

Antenna House XSL Formatter (Evaluation) http://www.antennahouse.com/


Commissioning with Startdrive
User interface - Control panel

See also
→ Using the control panel

This document constitutes a free excerpt compiled by the user himself/herself from the documentation provided by Siemens for this product. Siemens disclaims all liability for the
completeness of this document. It shall only be used for the user's own internal purposes. It shall not be passed on to third parties.
8/23/2020

Antenna House XSL Formatter (Evaluation) http://www.antennahouse.com/

You might also like