0% found this document useful (0 votes)
389 views11 pages

Final Year Project and Internship Report Template (Title) : Daffodil International University

Uploaded by

Md Emon
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
389 views11 pages

Final Year Project and Internship Report Template (Title) : Daffodil International University

Uploaded by

Md Emon
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 11

FINAL YEAR PROJECT AND INTERNSHIP REPORT TEMPLATE [Title] [bold, font

12]

BY

NAME
ID: XXX-XX-XXXX
AND

NAME
ID: XXX-XX-XXXX

This Report Presented in Partial Fulfillment of the Requirements for the


Degree of Bachelor of Science in Computer Science and Engineering [Font-14]

Supervised By

Name[Font-14, Bold]
Designation[Font-14]
Department of CSE
Daffodil International University

Co-Supervised By

Name[Font-14, Bold]
Designation[Font-14]
Department of CSE
Daffodil International University

DAFFODIL INTERNATIONAL UNIVERSITY [font-14, capital letter, bold]


DHAKA, BANGLADESH [font-14, bold]
DECEMBER 2019
APPROVAL[capital letter, Bold, Font-14, Alignment-middle]

This Project titled “Title”, submitted by *Name1* and *Name2* to the Department of
Computer Science and Engineering, Daffodil International University, has been accepted
as satisfactory for the partial fulfillment of the requirements for the degree of B.Sc. in
Computer Science and Engineering and approved as to its style and contents. The
presentation has been held on *date*.[Font-12]

BOARD OF EXAMINERS

(Name) [Font-12, Bold] Chairman


Designation
Department of CSE [Font-12]
Faculty of Science & Information Technology
Daffodil International University

(Name) Internal Examiner


Designation
Department of CSE
Faculty of Science & Information Technology
Daffodil International University

(Name) External Examiner


Designation
Department of -------
Jahangirnagar University

©Daffodil International University


DECLARATION[capital letter, Bold, Font-14, Alignment-middle]

We hereby declare that, this project has been done by us under the supervision of Name,
Designation, Department of CSE Daffodil International University. We also declare
that neither this project nor any part of this project has been submitted elsewhere for
award of any degree or diploma. [Font-12]

Supervised by:

Name
Designation
Department of CSE
Daffodil International University

Co-Supervised by:

Name
Designation
Department of CSE
Daffodil International University

Submitted by:

(Name1)
ID: -19-
Department of CSE
Daffodil International University

(Name2)
ID: -19-
Department of CSE
Daffodil International University

©Daffodil International University


ACKNOWLEDGEMENT
[capital letter, Bold, Font-16, Alignment-middle]

First we express our heartiest thanks and gratefulness to almighty God for His divine
blessing makes us possible to complete the final year project/internship successfully.

We really grateful and wish our profound our indebtedness to Supervisor Name,
Designation, Department of CSE Daffodil International University, Dhaka. Deep
Knowledge & keen interest of our supervisor in the field of “Field name” to carry out this
project. His endless patience ,scholarly guidance ,continual encouragement , constant and
energetic supervision, constructive criticism , valuable advice ,reading many inferior
draft and correcting them at all stage have made it possible to complete this project.

We would like to express our heartiest gratitude to -----, -----, and Head, Department of
CSE, for his kind help to finish our project and also to other faculty member and the staff
of CSE department of Daffodil International University.

We would like to thank our entire course mate in Daffodil International University, who
took part in this discuss while completing the course work.

Finally, we must acknowledge with due respect the constant support and patients of our
parents. [Font-12]

©Daffodil International University


ABSTRACT
[capital letter, Bold, Font-14, Alignment-middle]

[This is sample abstract] This report is intended as a guide for teachers and engineering
students when conducting research is part of course-work requirements. Discussion
includes a description of a literature search, the purpose of a literature review finding
sources (especially for engineering) and a general strategy to help conduct an efficient
and productive literature search. Using tools such as this report, students can become
more pro-active about their research projects. Teachers can use this report, among other
tools, to begin dialog with their students about expectations for research assignments.
Two key steps in a literature search are: (i) finding sources; and (ii) synthesizing
information. Each of these is addressed in two of the major sections in this report, as well
as how the literature search relates to the entire research process. Then pertinent
information is repeated in the summary section for convenience. An annotated reference
list is included for ease in finding other useful guidance. [Font-12]
Abstract should be between 200-300 words and a single paragraphs.

©Daffodil International University


TABLE OF CONTENTS [capital letter, Bold, Font-14, Alignment-middle]
CONTENTS[Font-14, bold] PAGE

Board of examiners[Font-12] i

Declaration ii

Acknowledgements iii

Abstract iv

CHAPTER[Font-14, Bold]

CHAPTER 1: CHAPTER NAME [Font-14, Bold] 1-6

1.1 Infrastructure Mode[Font-12] 1

1.2 2

APPENDIX 50-55

REFERENCES 56-57

©Daffodil International University


LIST OF FIGURES [Font-14, Bold]
FIGURES[Font-12,Bold] PAGE NO
Figure 1: Cabling and Computer Hardware[Font-12] 4
Figure 2.1.1: Numbering according to sub sections 11

©Daffodil International University


Instructions for figures:
a. Caption of every figure must insert at the bottom of the figure with center alignment.
b. Figure’s number and description must need to be mentioned in the main documents
about what it actually illustrates and what it explains.
c. Figure’s number must be sequenced according to the section numbers and arranges
with sub sections accordingly if needed.
d. All the figures must need proper citation if it used from other resources.

Sample:
The following figure 1 shows basic multicast service.

Figure 1: Basic multicast service [font-10, Alignment-center]

Figure 2.1.1: Probability of delay as a function of the fold number under different offered traffic (N=50,
n=14, q= 5, θ=. 31) [font-10, Alignment-center]

©Daffodil International University


LIST OF TABLES [Font-14, Bold]
TABLES[Font-12,Bold] PAGE NO
Table 1: Cabling and Computer Hardware[Font-12] 12
Table 2.1: Numbering according to sub sections 14

Instructions for Table:


1. Caption of every table must insert at the top of the table with center alignment.
2. Table’s number and description are must be mentioned in the main documents for what
it actually shows and what it explains.

TABLE 1: THE RELATIONSHIP BETWEEN GAZE TARGETS AND PROXEMICS FROM CASE 1 [FONT-10,
ALIGNMENT-CENTER]
Objects Persons
Proxemics Time of % Avg. Dur. Time of % Avg. Dur.
Area Target Target

List of Figures and List of Tables must be in separate pages.

Chapter writing style:


CHAPTER 1
©Daffodil International University
Introduction
Some Other Instructions:
Thesis/Project Size: Minimum 30 page limit for Bachelor program
Page Setup: Left- 1.25"
Right-1.25"
Top: 1.0-1.25"
Bottom-1.0-1.25"
Orientation- Portrait
Paragraph Line Spacing: 1.5
Column: Single column
Font: Time New Roman
Header: Bold, Capital letter, Alignment-Center, Font-14
Inner Text: Font-12, Plain text
Text Alignment: Justify
Figure caption: Font-10, Bottom, Center
Table caption: Font-10, Top, Center
Figure numbers for Appendix: It should be mentioned according to Appendix
number such as Figure A1, Figure B2 and so on.
Reference: Font-10
All references to books, papers, and other publications must be fully and correctly
quoted. There are several methods of quoting references. One is to state the name of the
author and a serial number in the main text with the full details of the reference in the
Reference section of the report, for example:

In the text:
....The analysis of the algorithms has been extensively reviewed by Yorozu et al. [1]
and will ....

In the References section:

[1] Y. Yorozu, M. Hirano, K. Oka, and Y. Tagawa, “Electron spectroscopy studies on magneto-optical
media and plastic substrate interface,” IEEE Transl. J. Magn. Japan, vol. 2, pp. 740–741, August 1987.

Conference/Journal Papers:

©Daffodil International University


[1] Author1, Author2, and Author3, “Paper Title”, Conference/Journal, Volume, page number, Month and
year.

Example:
[1] Y. Yorozu, M. Hirano, K. Oka, and Y. Tagawa, “Electron spectroscopy studies on magneto-optical
media and plastic substrate interface,” IEEE Transl. J. Magn. Japan, vol. 2, pp. 740–741, August 1987.

Books:
[2] Author, Book Title, Edition/Volume, Publisher, Year, Page number

Example:
[2] T. H. Cormen, C. E. Leiserson, R. L. Rivest, C. Stein, Introduction to Algorithms, 3rd Edition, The MIT
Press, 2009, pp. 120-122.

Websites:
[3] Name/Title of the Website, available at << https://URL>>, last accessed on Date at Time.

Example:
[3] Learn about Wikipedia, available at << http://www.wikipedia.org/>>, last accessed on 06-06-2019 at
12:00 PM.

©Daffodil International University

You might also like