Scribd
Upload
23 views3 pages

USB3 Camera Firmware Update Instructions

The document provides instructions for updating the firmware on a PowerScan camera. It is a 12 step process that involves turning off the scanner, installing software, running an executable to check for firmware updates, programming the camera with the new firmware, and verifying the update. The process should not be interrupted as it updates the firmware, FPGA, and XML files on the camera.

Uploaded by

Aquiles Davila
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
23 views3 pages

USB3 Camera Firmware Update Instructions

The document provides instructions for updating the firmware on a PowerScan camera. It is a 12 step process that involves turning off the scanner, installing software, running an executable to check for firmware updates, programming the camera with the new firmware, and verifying the update. The process should not be interrupted as it updates the firmware, FPGA, and XML files on the camera.

Uploaded by

Aquiles Davila
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Updating Camera Firmware for PowerScan

version X.340
1) Turn off your ScanPro before installing PowerScan software.
2) Install PowerScan software.
3) When software installation completes, turn on ScanPro.
4) Navigate to the FirmwareUpdater_Wizard.exe and shown below.

5) Double click “FirmwareUpdater_Wizard.exe” and the window below will appear.


6) Click “Next” and the window below will appear.

7) Click “Check For New Firmware” and the “Firmware File”, “FPGA File”, and “XML File” text boxes will be populated
as show below.
8) Click “Program Camera” and the warning below will appear.

9) Click “OK” and programming of the camera will begin. First the Firmware, then the FPGA, and lastly the XML. Do
not interrupt this process. Be patient. When it is nearly finished the following window will appear as it attempts to
verify the update and communicate with the camera.

10) When finished the window will appear as below.

11) Click “Exit” to finish.


12) You may now start PowerScan and use your ScanPro.

You might also like