Scribd
Upload
106 views1 page

NovemberDecember 2020

This document is an exam for a course on analog and digital communications. It contains 8 questions covering various topics: 1) Reconstruction of a DSB-SC signal and power relations in AM waves. 2) Detection of an AM signal using an envelope detector and analysis of a phase modulated signal. 3) Spectrum analysis of FM using Bessel functions and modulation/demodulation of phase and frequency modulated signals. 4) Limitations of a TRF receiver and characteristics/purpose of an RF tuner. 5) Acceptable sampling frequency range for a bandpass signal and block diagram/function of PCM components. 6) Analysis of adequate sampling rates for a bandpass signal with

Uploaded by

Poongodi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
106 views1 page

NovemberDecember 2020

This document is an exam for a course on analog and digital communications. It contains 8 questions covering various topics: 1) Reconstruction of a DSB-SC signal and power relations in AM waves. 2) Detection of an AM signal using an envelope detector and analysis of a phase modulated signal. 3) Spectrum analysis of FM using Bessel functions and modulation/demodulation of phase and frequency modulated signals. 4) Limitations of a TRF receiver and characteristics/purpose of an RF tuner. 5) Acceptable sampling frequency range for a bandpass signal and block diagram/function of PCM components. 6) Analysis of adequate sampling rates for a bandpass signal with

Uploaded by

Poongodi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Code No: 154AC R18

JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD


JN
B.Tech II Year II Semester Examinations, November/December - 2020
ANALOG AND DIGITAL COMMUNICATIONS
(Electronics and Communication Engineering)
TU
Time: 2 hours Max. Marks: 75
Answer any Five Questions
All Questions Carry Equal Marks
---
H
1.a) The signal m(t) in the DSB – SC signal v(t) = m(t) cos (ωc t + Ɵ) is to be reconstructed
by multiplying v(t) by a signal derived from v2(t). Show that v2(t) has a component at
the frequency 2fc. Find its amplitude.
U
b) Explain power relations in AM waves. [8+7]
SE
2.a) The signal v(t) = (1+m cos ωm t) cos ωc t is detected using a diode envelope detector.
Sketch the detector output when m=2.
b) Consider the signal cos [ωc t + ϕ(t)] where ϕ(t) is a square wave taking on the values
±π/3 every 2/fc sec.
D
i) Sketch cos [ωc t + ϕ(t)]
ii) Plot the phase as a function of time
iii) Plot the requency as function of time. [7+8]
21
3.a) Explain spectrum analysis of sinusoidal FM wave using Bessel functions.
b) If the waveform cos(ωc t + k sin ωm t) is a phase modulated carrier, sketch the
-1
waveform of the modulating signal. Sketch the waveform of the modulating signal if
the carrier is frequency modulated. [8+7]
1-
4.a) What are the limitations of TRF receiver? How to over come them?
b) What are the characteristics of RF Tuner? Why it is needed in receivers. [8+7]
20
5.a) A bandpass signal has a spectral range that extends from 20 to 82 kHz. Find the
acceptable range of the sampling frequency, fs.
b) Draw the block diagram of PCM and explain function of each block. [6+9]
2
6.a) A bandpass signal has a center frequency f0 and extends from f0 – 5kHz to f0 + 5kHz.
0A
The signal is sampled at a rate fs = 25kHz. As the center frequency f0 varies from 5kHz
to 50kHz, find the ranges of f0 for which the sampling rate is adequate.
b) Compare DPCM, DM and PCM in all aspects. [7+8]
M
7.a) Describe coherent ASK detector and compare it with non coherent detector.
b) The bit stream 11011100101 is to be transmitted using DPSK. Determine the encoded
sequence and the transmitted phase sequence. Show that the phase comparison scheme
can be used for demodulating the signal. [6+9]

8.a) What are applications of eye diagrams?


b) Derive the equation for probability of error using BPSK in Base band transmission.
[5+10]
---ooOoo---

You might also like