Scribd
Upload
63 views2 pages

Covers: 6.3. Covers Series CPTA in Steel

This document discusses covers for belt conveyors made of galvanized steel. The covers are designed to protect materials being conveyed, the environment, and operators from dust, noise, weather, and to extend the life of the belt. Standard covers are made from galvanized steel sheets with a thickness of 0.75mm and corrugated sections. Custom covers can be made from other materials like aluzinc, aluminium, or stainless steel depending on needs.

Uploaded by

Dwi Setyaone
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
63 views2 pages

Covers: 6.3. Covers Series CPTA in Steel

This document discusses covers for belt conveyors made of galvanized steel. The covers are designed to protect materials being conveyed, the environment, and operators from dust, noise, weather, and to extend the life of the belt. Standard covers are made from galvanized steel sheets with a thickness of 0.75mm and corrugated sections. Custom covers can be made from other materials like aluzinc, aluminium, or stainless steel depending on needs.

Uploaded by

Dwi Setyaone
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

6 Covers

6.3. Covers series


CPTA in steel

6.3 - Covers series CPTA in steel For the protection of the materials: environmental conditions and the
- with reduction of maintenance to the conveyed materials:
The covers shown in this catalogue are structures Z45: Z=450 hot galvanisation, 16.0 μ each side
the result of many years’ experience and - to avoid loss of materials and productivity Z60: Z=600 hot galvanisation, 21.5 μ each side
cooperation with engineering companies due to wind
and constructors specialising in belt - to avoid deposits of rain water on the belt Other types of covering:
conveyor design. - to assure the efficiency of the industrial PPE: Pre-Painting on galvanised steel
constructions linked to the belt. Z 225 polyester 25 μm
Why cover belt conveyors? PVD: PVDF 35 μm
Material: polyvinyl thermoplastic resin
To protect the conveyed material. - galvanised steel for construction SOL: Solifarm 25/35 μm
To protect the environment: according to EURONORM EN 10 147 of soft polyester resin
- against dust 1996 PVL: Plastisol 100 μm
- against noise - class S 220 GD + Z 1.0241 thermoplastic resin of polyvinyl
- and for a better integration in the chloride
landscape. - Z35 Standard covering:
Z 350 hot galvanisation on both sides Other materials on request:
For the operators’ safety. 12.5 μm each side. ALZ: aluzinc AZ 185
For the protection of the belt: AL: aluminium
- against the sun and bad weather Covering options according to the I04: stainless steel AISI 304
- and for a longer life. I16: stainless steel AISI 316

292
Characteristics
Produced from galvanised sheet steel - Standard thickness 0,75 mm.
corrugated section 18/76 for all belt - For intermediate covers the thickness
conveyors but normally used for belt varies according to the radius (see the
widths of 400 mm upwards. table at the following page).

Length:

Standard lay-out Standard lay-out (with alternate covers 180° - 135°)

Lay-out with intermediate module at 180° and covers at 135°


(allowing a better view of the belt)

293

You might also like