This document provides information on engine timing and fuel injection pump settings for Phaser/1000 series engines. It specifies that the piston position probe is used to set the engine check angle to 100 degrees before top dead center. For engines with a check angle less than 100 degrees, a washer of a specified thickness must be fitted to the piston position probe. A table shows the required washer thickness for different fuel pump codes and engine check angles.
This document provides information on engine timing and fuel injection pump settings for Phaser/1000 series engines. It specifies that the piston position probe is used to set the engine check angle to 100 degrees before top dead center. For engines with a check angle less than 100 degrees, a washer of a specified thickness must be fitted to the piston position probe. A table shows the required washer thickness for different fuel pump codes and engine check angles.
This document provides information on engine timing and fuel injection pump settings for Phaser/1000 series engines. It specifies that the piston position probe is used to set the engine check angle to 100 degrees before top dead center. For engines with a check angle less than 100 degrees, a washer of a specified thickness must be fitted to the piston position probe. A table shows the required washer thickness for different fuel pump codes and engine check angles.
This document provides information on engine timing and fuel injection pump settings for Phaser/1000 series engines. It specifies that the piston position probe is used to set the engine check angle to 100 degrees before top dead center. For engines with a check angle less than 100 degrees, a washer of a specified thickness must be fitted to the piston position probe. A table shows the required washer thickness for different fuel pump codes and engine check angles.
Fuel injection pump Fuel pump type .. ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... . MW Direction of rotation from drive end ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... Clockwise Outlet for number 1 cylinder... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... Drive end of fuel pump Static timing The piston position probe 21825630 or 21825947 is used to set the engine check angle to 100° BTDC. A locally made washer (A) must be fitted onto the piston position probe when the engine check angle is less than 100° BTDC. The thickness of the piston position probe washer, dimension A, for a particular engine is shown in the table below. The general dimensions for the piston position probe washer are shown in (A). Piston position probe washer Engine check angle Fuel pump code thickness (degrees) (mm) WM 98 2,302 HL 100 - LC 100 - MC 100 - VK 100 -
