0% found this document useful (0 votes)
101 views3 pages

US5Ge Next Generation SSU PRC GPS Based

The US5Ge is a modular, redundant timing signal generator that provides synchronization outputs for packet and TDM networks through protected timing cards. It supports a variety of reference inputs, integrated dual GPS receivers, and remote management through SNMP and TCP/IP. The system architecture includes a main shelf with dual power supplies, clocks, and outputs, and optional expansion shelves for additional ports.

Uploaded by

charleskawuma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
101 views3 pages

US5Ge Next Generation SSU PRC GPS Based

The US5Ge is a modular, redundant timing signal generator that provides synchronization outputs for packet and TDM networks through protected timing cards. It supports a variety of reference inputs, integrated dual GPS receivers, and remote management through SNMP and TCP/IP. The system architecture includes a main shelf with dual power supplies, clocks, and outputs, and optional expansion shelves for additional ports.

Uploaded by

charleskawuma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

US5Ge - Protected Outputs

ENABLING NEXT GENERATION CARRIER NETWORK SYNCHRONIZATION ...

The Universal Sync 5G--US5G(e) is a full-featured US5Ge units comply with all ITU-T recommendations,
Timing Signal Generator (TSG) intended to supply ETSI standards (US5Ge) and Telcordia Generic
timing distribution to network elements for TDM and Requirement (GR) network synchronization equipment
packet networks. It is designed to function as a Primary standards and with the Regional Bell Operating Company
Reference Clock (PRC), Synchronization Supply Unit (RBOC) network operations common practices (US5G).
(SSU), Building Integrated Timing Supply (BITS) and These include but are not limited to: ITU-T G.812, ITU-T
IEEE 1588 PTP GrandMaster Clock for common clock G.813, ITU-T G.823, ITU-T G.8265, ETSI 300 462-3/4/5,
distribution to all Network Elements (NE’s) requiring GR-1244-CORE, GR-378-CORE, GR-436-CORE, GR-474-
external timing for synchronization. CORE, GR-833-CORE, and GR-1093-CORE.

The growth of data traffic keeps challenging Telecom


Services Providers with the migration from traditional
TDM-based backhaul solutions to packet-based
networks. US5Ge units that incorporate IEEE 1588 PTP
V2 GrandMaster Clock 1+1 protected blades and SyncE
interfaces meet their frequency, phase and time
synchronisation needs.

REMOTE MANAGEMENT
All software management interfaces are remotely accessible
via TCP/IP LAN allowing full utilization of Centralized Network
Operations Center for monitoring and management.

SYSTEM FEATURES
♦ Auto-provisioning of all modules during installation and
initialization
♦ Upon insertion of a replacement module :
- Automated Hardware and Software compatibility
checks
- Automated Software download of current module
software when required
- Provisioning from current database
♦ Inventory in software:
- Input reference source
- Output port assignment
♦ Inventory and Mfg Serial Number in software to help in
field servicing and PCN administration
♦ TL-1 Command Line Interface
♦ SNMP protocol
♦ NTP client/server card (hardware assistance, 2 LAN ports):
1+1 redundant
♦ Protected Output cards :
- E1 + 2.048 MHz card (20/40 ports)
- DS1 + CC card (20/40 ports)
♦ IEEE 1588 PTP GrandMaster card : 1+1 redundant
♦ Optional Output card with Frequency Feedback (20 ports
and 20 Frequency Feedback input ports)
♦ Internal GPS with or without “Antenna converter”

Mont Saint-Martin 58—B-4000 LIEGE—BELGIUM


Tel.: +32 (0) 4 232 95 95—Fax : +32 (0) 4 223 42 76
Email : [email protected]—internet : www.gillam-fei.be
Modular Redundancy in Hardware

♦ Dual Power Inputs & Power Supplies


♦ Up to 10 References Inputs
♦ Inputs bridge to both IOP Modules
♦ Dual GPS Reference Receivers (Optional)
♦ Dual GPS Antenna Inputs
♦ Dual IOP’s (ST-2 or ST-3E)
♦ Dual Redundant umbilicals directly connected to
each expansion shelf

Microprocessor Control & Memory Features

♦ Top level IntelTM microprocessors on COM and both


IOP modules
♦ System Databases stored on the COM module are
backed up on BOTH IOP’s
♦ Output Module on-board microprocessors enable
management to each output port

Oscillator Options

♦ Standard Quartz ST-3E & Rubidium ST-2


♦ Optional Stratum 2 High Precision Double Oven
Quartz Oscillator (DOCXO) - ST-2 performance at
lower cost

System Communications Interfaces

♦ 3 Local craft interfaces (1 at the front panel)


♦ TCP / IP Local Area Network interface via RJ-45

Integrated GPS Receiver

The US5Ge is designed to integrate two GPS


receivers. This arrangement optimizes rack bay
utilization by eliminating separately mounted
GPS units. The GPS references are independent
of other input capacity, meaning all other
inputs are still available for selection or for
monitor only operation.

Alarm Reporting Modes

♦ Module Status and Alarm LED’s


♦ 6 Contact Closure Relays—Local &
Remote
♦ TL-1 Autonomous Output Messages
♦ SNMP Traps
♦ 16 Discrete Alarm Input Relays
♦ Alarms reported for Expansion shelf
umbilicals & BYPASS module faults

Mont Saint-Martin 58—B-4000 LIEGE—BELGIUM


Tel.: +32 (0) 4 232 95 95—Fax : +32 (0) 4 223 42 76
Email : [email protected]—internet : www.gillam-fei.be
US5Ge—Protected Outputs
PRODUCT SPECIFICATIONS
Architecture
Main shelf : 1 COM card, 2 power supplies, 2 IOP clocks with maximum 10 inputs each, 2 GPS, 8 output cards
(max 160 1+1 output ports)
Optional: Bypass module (third clock for emergency situation)
Up to 4 expansion shelves: 2 power supplies, 16 output cards (max 320 1+1 output ports) per shelf
Fast interface bus for inter-cards communication
Local and remote management; software download for all active modules (IOP modules, COM card, Output Cards)
Safe Data Base management; duplication of Data base on COM card and on both clock modules

Power supply modules


Dual load sharing
Each receives power from dedicated back panel power input
Automatic redundancy in case of module failure
Front panel fuses and power status led’s
Dual -35 to -72VDC

Communication Module (COM card)


System manager for all plugged in modules : provisioning, alarming, firmware upgrade, inventory, ...
Supports TL-1 and SNMP agents for equipment supervisory
Manages all system security processes
Manages all DB storage, access & synchronisation with IOP back up
Powerful CPU with real time kernel.
3 RS232: CRAFT 1,2,3
1 ETHERNET RJ45: 4x TELNET + 6x TCP/IP sessions
EVENT LOG (1000)
EVENT AO LOG (500)
SECU LOG (500)
DBCHG LOG (500)
SNTP & NTP stratus 1 on board (request GPS option)
Performance measurement : buffering, log and alarm for Clock module PM data

Clock modules (IOP modules)


Based on Rubidium or quartz oscillator, possibility of mixed configuration
Dual redundant clock modules
Clock performance : ITU-T G.812 type 1 & 2 or ANSI T1.101 type ST2 or ST3E
Universal input module : E1, DS1, 1-5-10 MHz, 1544 KHz, 2048 kHz, 64 kHz CC
Maximum 10 input modules per clock module (input impedance 75 and 120 Ohm)
Each input can be used as reference or measurement input
SSM: full compliant (ITU-T G.704, Telcordia GR-378), possibility of QL assignment for no SSM capable inputs
Full software manageable: diagnostic alarms, automates for clock state administration
Powerful CPU with real time kernel
Performance Measurement : TIE, MRTIE, TDEV, FFOFF for several time intervals (1s to 10000s)

GPS
Single or dual GPS modules
Dual Antennas inputs
GPS input with or without long distance cable interface (antenna converter)

Outputs
E1 + 2.048 MHz Protected card (20/40 ports)
DS1 + CC Protected card (20/40 ports)
NTP client/server card (hardware assistance, 2 LAN ports): 1+1 redundant
IEEE 1588 PTP GrandMaster card : 1+1 redundant
Output card with Frequency Feedback (20 ports and 20 Frequency Feedback input ports)

Environmental
Operating temperature: 0 to 50°c
Humidity: 5 to 95%
Dimensions: H=270mm; W=430mm; D=280mm
NEBS level 3
ROHS Compliant

Mont Saint-Martin 58—B-4000 LIEGE—BELGIUM


Tel.: +32 (0) 4 232 95 95—Fax : +32 (0) 4 223 42 76
Email : [email protected]—internet : www.gillam-fei.be

You might also like