0% found this document useful (1 vote)
3K views5 pages

KESS V2 Wake Up Error, How To Solve?

The document provides troubleshooting steps for resolving a "Wake up error" that occurs when running the Kess v2 device. Possible causes include a loose or improperly soldered chip on the main board that prevents reading programs from the TF card. Recommended steps are to re-solder the chip, clean the card slot, and ensure proper contact. If the error persists, the document outlines formatting the TF card, recopying the software files directly to the card without creating new folders, and as a last resort, reflashing the CPU program.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
0% found this document useful (1 vote)
3K views5 pages

KESS V2 Wake Up Error, How To Solve?

The document provides troubleshooting steps for resolving a "Wake up error" that occurs when running the Kess v2 device. Possible causes include a loose or improperly soldered chip on the main board that prevents reading programs from the TF card. Recommended steps are to re-solder the chip, clean the card slot, and ensure proper contact. If the error persists, the document outlines formatting the TF card, recopying the software files directly to the card without creating new folders, and as a last resort, reflashing the CPU program.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
You are on page 1/ 5

KESS V2 Wake up error, How to Solve?

If you get "Wake up error" when running Kess v2 as the following

picture shows.

Possible reasons for wake up error:

Kess v2 fails to read out TF card program or the program in the TF card

is not working properly.

2 reasons for Kess v2 fails to read out TF card program.

1) The four pins of chip are not soldered firmly on the main board.

2) The chip is loose for a long time of use.


Try to do as following instruction:

1) Solder the chip once more to make it tightly connected to the main

board.

2) Clean up the shrapnel on the card slot with a brush.

3) Lift up the shrapnel a little bit to make sure it can well communicate

with the TF card, if the card slot shrapnel is not flexible enough.

4) Clean the TF card and then put it back to the card slot.
If the wake up error stays, format the card and then copy the software

back to the card.

It is easy 3 basic steps, pay attention to the important note.

1. Format TF card

2. Ask us to send you the software in the TF card

3: decompress the file, choose them all, copy and paste to TF card.

(IMPORTANT NOTE: Don’t directly copy the compressed file to TF

card; don’t create a new folder in TF card and copy decompressed file

into it.)
(1. Decompress file: kessv2 up)

(2. Copy the 4 files and paste to TF card)


(Wrong operation)

If the two methods above do not work out wake up error, reflash the

CPU program, and then copy and paste the software to the TF card

again. The procedure to reflash CPU is as the same as that to solve

token limitation as the following link shows:

http://www.obd365.com/upload/service/how-to-program-kess-v2-toke

ns-chip-obd365.pdf

You might also like