Scribd
Upload
419 views3 pages

Making-Cable Mitsubishi SC09 PLC Programming Cable

This document provides instructions for making a programming cable to connect a Mitsubishi PLC, such as an FX series PLC, to a computer. It describes the common cable types used for Mitsubishi PLCs, which have either an 8-pin connector to connect to the PLC and a COM DB9 or USB connector for the computer. The instructions then outline the materials needed to make a cable, including a MiniDIN-8P male jack for the PLC connection, a COM-DB9 female jack for the computer, and a 500-ohm or 1000-ohm resistor. It provides a wiring diagram and notes that the author successfully made this cable to program a PLC like

Uploaded by

The Manh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
419 views3 pages

Making-Cable Mitsubishi SC09 PLC Programming Cable

This document provides instructions for making a programming cable to connect a Mitsubishi PLC, such as an FX series PLC, to a computer. It describes the common cable types used for Mitsubishi PLCs, which have either an 8-pin connector to connect to the PLC and a COM DB9 or USB connector for the computer. The instructions then outline the materials needed to make a cable, including a MiniDIN-8P male jack for the PLC connection, a COM-DB9 female jack for the computer, and a 500-ohm or 1000-ohm resistor. It provides a wiring diagram and notes that the author successfully made this cable to program a PLC like

Uploaded by

The Manh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

[Making-Cable] Mitsubishi SC09 PLC Programming

Cable
plc247.com/making-cable-mitsubishi-sc09-plc-programming-cable/

plc247.com November 4, 2020

Two types of cables are common for Mitsubishi PLCs. The first is the one with an 8-pin
round end that can be used for all types of FX series plc, the other end out to COM DB9 or
a USB port to connect directly to a computer. The second type is available on some newer
series of plc such as FX3S, FX3G, FX5U includes 1 mini USB for connecting to PLC, the
other end is USB for connecting to computer.

In this article, I will guide you to make 1 Cable used to connect to PLC FX-Series quickly
and easily.

Preparation

1. MiniDIN-8P Male jack ( Plugs into the Mitsubishi FX-Series PLC )

1/3
2. Jack port COM-DB9 Female ( Connect to a computer )

3. Resistor

Have you prepared a 500-Ohm or 1000-Ohm (1K) resistor

MARKING CABLE
You conduct cable welding according to the following chart

2/3
plc247.com has made this cable successfully and has tried to work with the PLC like a
genuine USB-SC09 cable. You guys just do it right as this is the activity

Please like and share if you find the article useful!

3/3

You might also like