0% found this document useful (0 votes)
514 views1 page

Description of DWIN K600+ Kernel Based UART LCM Interface

The document describes the interfaces of DWIN K600+ kernel based UART liquid crystal display modules. It has two common interfaces: an 8 pin 2.54mm connector and a 10 pin 1mm connector. Jumpers can be used to select the voltage level and serial communication standard. The default settings are for RS232 serial ports with a voltage range of 5.0-42.0V.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
514 views1 page

Description of DWIN K600+ Kernel Based UART LCM Interface

The document describes the interfaces of DWIN K600+ kernel based UART liquid crystal display modules. It has two common interfaces: an 8 pin 2.54mm connector and a 10 pin 1mm connector. Jumpers can be used to select the voltage level and serial communication standard. The default settings are for RS232 serial ports with a voltage range of 5.0-42.0V.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PF600SD INTRODUCTION Professional, Creditable and Successful

Description of DWIN K600+ Kernel Based UART LCM


Interface

Except for DWIN K600+ kernel based UART UCM interface adopted by C series
(consumer application), all other DWIN K600+kernel based UART UCM have two interfaces:
Interface 1: 8 Pin_2.54mm space 8Pin outlet;
Interface 2: 10 Pin_1.0mm space FCC outlet.

These two interfaces are in a parallel circuit, user can choose one based on their needs.
Since these two interfaces are in a parallel circuit, so the same time power-on is absolutely
forbidden.

In order to be compatible with interfaces of other models and to be user-friendly, most


DWIN K600+ kernel based UART UCMs have two jumper pads, and users can realize
interface compatibility by setting different jumper mode.
Jumper values are listed as below:

Power Jumper Serial Ports Jumper


Mode ON=3.3-6.0V ON=3.3V CMOS Instruction
OFF=5.0-42V OFF=RS232
UART UCM interface
VCC=3.3-6V
for C series
TTL/CMOS ON ON
HDL662 USB
Serial Ports
Adjusting Outlet
VCC=3.3-6V
ON OFF
RS232 Serial Ports
VCC=5.0-42.0V
TTL/CMOS Serial OFF ON
Ports
VCC=5.0-42.0V
OFF OFF Factory Default
RS232 Serial Ports

Copyright@ Beijing DWIN Technology Co.,Ltd.2012. All Rights Reserved 1

You might also like