0% found this document useful (0 votes)
21K views2 pages

Universiti Tun Hussein Onn Malaysia: Faculty of Mechanical and Manufacturing Engineering

This document provides instructions and assessment criteria for Assignment 1 of the BDA 30903 Solid Modelling course. Students are asked to draw a given object using Solidworks sketch within 30 minutes. The assessment will be based on 4 criteria: 1) fully defining the object, 2) producing the correct and complete shape, 3) including the correct dimensions, and 4) using proper and tidy dimensioning. Points will be awarded according to rubrics provided for each criteria, with a total of 5 points possible.

Uploaded by

Ahmad Faidhi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
21K views2 pages

Universiti Tun Hussein Onn Malaysia: Faculty of Mechanical and Manufacturing Engineering

This document provides instructions and assessment criteria for Assignment 1 of the BDA 30903 Solid Modelling course. Students are asked to draw a given object using Solidworks sketch within 30 minutes. The assessment will be based on 4 criteria: 1) fully defining the object, 2) producing the correct and complete shape, 3) including the correct dimensions, and 4) using proper and tidy dimensioning. Points will be awarded according to rubrics provided for each criteria, with a total of 5 points possible.

Uploaded by

Ahmad Faidhi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

FACULTY OF MECHANICAL AND MANUFACTURING ENGINEERING

UNIVERSITI TUN HUSSEIN ONN MALAYSIA


BDA 30902, SOLID MODELLING
Assignment 1

Draw the following object using Solidworks – sketch. All dimension in mm. Durations 30 mins.

Assessment

1. Fully define, 1.5 mark


2. Complete and correct shape, 1.5 mark
3. Correct dimensions, 1.5 mark
4. proper and tidy dimensioning , 0.5 mark
Total 5.0 marks

BDA 30903 SOLID MODELLING, Assignment 1, sem 1 20142015


Marking scheme for assignment 1

Criteria
Strong Weak

2 2< All
Fully 1 undefined
undefined undefined undefined
1 Fully define define curve/ line
curve /line curve/ line curve/ line

1.5 1.2 0.8 0.5 0

2 Complete and The shape The shape is 50% > of 50 % > of 50% < of
correct shape is correct correct but the shape the shape the shape
and fully not is incorrect is incorrect incorrect
define with dimensioned + without with or
dimensions dimensions any without
dimensions dimensions

1.5 1.0 0.8 0.5 0

3 Correct 15 12 – 14 9 - 11 6-8 >5


dimensions dimensions dimensions dimensions dimensions dimensions
correct correct correct correct correct

1.5 1.0 0.8 0.5 0

4 proper and Yes No


tidy
dimensioning 0.5 0

BDA 30903 SOLID MODELLING, Assignment 1, sem 1 20142015

You might also like