RCD400BT: Portable CD /Mp3/Usb/ Radio/ Bluetooth
RCD400BT: Portable CD /Mp3/Usb/ Radio/ Bluetooth
PORTABLE CD /MP3/USB/
RADIO/ BLUETOOTH
OPERATING INSTRUCTIONS
PLEASE READ THIS USER MANUAL CAREFULLY BEFORE
OPERATING THIS UNIT AND RETAIN FOR
FUTURE REFERENCE.
Rev 1 1 GB
WARNING
CLASS 1 LASER PRODUCT
CAUTION
CLASS 1 LASER PRODUCT INVISIBLE LASER RADIATION
APPAREIL Á LASER DE CLASSE 1 WHEN OPEN AND INTERLOCKS
PRODUCTO LASER DE CLASE 1 DEFEATED.
AVOID EXPOSURE TO BEAM
PRECAUTIONS
Follow the advice below for safe and appropriate operations.
ON PLACEMENT
• Do not use the unit in places which are extremely hot, cold, dusty, or humid.
• Place the unit on a flat and even surface.
• Do not restrict the air flow of the unit by placing it in a place with poor air flow, by covering it with a cloth,
or by placing it on a carpet.
ON SAFETY
• When connecting and disconnecting the AC cord, grip the plug and not the cord itself. Pulling the cord may damage
it and create a hazard.
• When you are not going to use the unit for a long period of time, disconnect the AC power cord.
ON AC VOLTAGE
• Before use, check that the rated voltage of your unit matches your local voltage.
ON CONDENSATION
• When left in a heated room where it is warm and damp, water droplets or condensation may form inside the CD player.
• When there is condensation inside the unit, the unit may not function normally.
• Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the unit before use.
* Ensure a minimum distance of 2 feet around the apparatus for sufficient ventilation.
* Ensure that the ventilation is not impeded by covering the ventilation openings with items, such as newspapers,
table-cloths, curtains, etc..
* Do not place near flame sources, such as lighted candles on the apparatus.
* Pay attention to the environmental aspects of battery disposal.
* Use the apparatus only in moderate climates (not in tropical climates).
* Do not expose the apparatus to dripping or splashing.
* Do not place objects filled with liquids, such as vases, on the apparatus.
• Mains plug is used as the disconnect device. It should remain readily operable and should not be obstructed during
intended use. To be completely disconnected from supply mains, the mains plug of the apparatus should
be disconnected from the mains socket outlet completely.
Should any trouble occur, disconnect the AC power cord and refer servicing to qualified personnel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with ATTENTION : To reduce the risk The exclamation point within
arrowhead symbol of electric shock, do not remove the the triangle is a warning sign
within the triangle is a alerting the user of important
cover. There are no user serviceable instructions accompanying
warning sign alerting
the user of "dangerous parts inside the unit. Refer all servicing the product.
voltage" inside the unit. to qualified personnel.
In case of malfunction due to electrostatic discharge,the apparatus has to be reset by disconnecting it from mains supply.
THE MARKING PLATE IS LOCATED AT THE BOTTOM OF ENCLOSURE.
2 GB
LOCATION OF CONTROLS
3 GB
REMOTE CONTROL UNIT
MUTE BUTTON POWER/STANDBY BUTTON
FUNCTION BUTTON
REPEAT BUTTON
PLAY/PAUSE BUTTON PROGRAM BUTTON
MONO/STEREO
FOLDER UP / MEMOREY UP BUTTON
FOLDER DN / MEMOREY DN BUTTON
B-SKIP/DN BUTTON F-SKIP / UP BUTTON
VOLUME - + VOLUME
STOP BUTTON
POWER SUPPLY
USING HOUSE CURRENT
Before use, check that the rated voltage of your unit
matches your local voltage.
battery door
Insert eight UM-2
( size C ) batteries.
4 GB
AUX. IN
An external (auxiliary) audio source (i.e., personal CD player
or MP3 player) can be connected to this unit and heard through
the speakers.
1) Plug one end of cable into the AUX IN socket on the unit. AUX. IN
2) Plug the other end of the cable into the Headphone or
Line Out socket of the external source. LCD display
3) Press the FUNCTION button to select AUX. (Plug other end into external
source such as an MP3 player.) FUNCTION
Continue to operate CD or MP3 player as usual.
Selections will be heard through the unit's speakers.
Unit will be automatically off after 4.5 hours without further operation.
LCD display
CLOCK ADJUSTMENT
The clock is displayed �������������������������������
on LCD display at standby mode. LCD display
1. Press and hold the PROGRAM / CLOCK-ADJ. button.
2. Press the NEXT or BACK to select 12 hours or 24 hours display.
3. Press the PROGRAM / CLOCK-ADJ. button, ���������������������
the hour digit flash.
4. Press the NEXT or BACK to adjust hour digit. CLOCK-ADJ.
5. Press the PROGRAM / CLOCK-ADJ. button, the minute digit flash.
6. Press the NEXT or BACK to adjust minute digit.
7. Press the PROGRAM / CLOCK-ADJ. button again, the correct time
is shown on display.
POWER
5 GB
5 . At FM, press FM ST. / MONO button to select 6. Adjust the sound.
stereo sound.The FM stereo indicator (St) will
appear on the LCD display panel when an
FM Stereo Broadcast is received. When FM
signal is weak and sound distortion occurs,
VOLUME VOLUME
it is better to select mono sound.
MONO/ STEREO
LCD display
AFTER LISTENING
FM
Turn off the unit by pressing POWER button.
POWER
2 . Press the FUNCTION button to
select CD. The symbol " _ _ _ " flashes
for searching CD disc.
4. Insert a disc with the label side facing up.
5 . Close the CD door.
The disc will rotate and
LCD display the total tracks of the disc
will show on the display.
FUNCTION
6 GB
6. Press the PLAY/PAUSE button. TO INTERRUPT PLAYBACK
Track number "01" ," CD "& the symbol " " will Press the Play/Pause button and the symbol
be shown during normal compact disc playback. " " will flash. Press the button again to
Track number "001"," CD ", the symbol " "& resume playback.
PLAY/PAUSE
"MP3"will be shown during MP3 playback.
Track number "001"," CD ", the symbol " "&
"WMA" will be shown during WMA playback.
Track number "001", the symbol " " & "USB"
will be shown during USB playback.
CD display WMA display
PLAY/PAUSE
TO STOP PLAYBACK
Press the STOP button and the display shows the
MP3 display USB display total tracks of the disc.
STOP
Unit will be automatically off after 15 mins without further operation (in stop mode / CD door open).
7 GB
FOLDER UP / DN
- Press FOLDER UP or FOLDER DN ( on remote ) button to
select desired folder. folder up
- Press B-SKIP
�������������������������������������������������������
/ DOWN button or F-SKIP / UP
button to
������������������������
select desired track.
- Press PLAY/PAUSE button to start playing.
PROGRAM CD/USB
USB OPERATION
1. Connect USB disk or MP3 player into the USB port.
2. Press FUNCTION button to select USB.
3. Press PLAY/PAUSE button to start playback. USB display
note:
USB connector does not support connection with USB extension cable and
it is not designed for communication with computer directly.
Manufacturer is not responsible for the playability of USB disk or MP3 player
FUNCTION
due to recording condition, capacity, interface compatibility, etc.
Due to different formats, some USB disks or MP3 players may take longer time to be read.
USB stick is direct connected or with a cable with max. 0,5 m length.
Unit will be automatically off after 15 mins without futhur operation (in stop mode).
8 GB
BLUETOOTH OPERATION
1 . Turn on the unit by 3 . On your Bluetooth device, activate
pressing the POWER button. Bluetooth and search for F-6188.
The bluetooth LED indicator
flashes during pairing.
POWER BLUETOOTH
2. Press the FUNCTION button to
select BLUETOOTH. The " BT " is shown on the display. 4. Connected : Bluetooth LED indicator is always light
on.
- Next time you switch on the unit, the speaker connects to the last paried device automatically.
- The music streaming may be interrupted by obstacles between the device and the unit, such as walls, or other devices
nearby that operate in the same frequency.
Unit will be automatically off after 15 mins without further operation.
MAINTENANCE
CLEANING CD CLEANING THE CD LENS
If the CD skips or will not play , the disc may need cleaning If the CD lens is dusty, clean it with a brush-blower. Blow
. Before playing, wipe the disc several times on the lens and remove the dust with the
from the centre out with a brush. Finger prints may be removed with a cotton swab
cleaning cloth. After playing, moistened with alcohol.
store the disc in its case.
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly
wiping with a soft cloth.
IMPORTANT NOTE
If an abnormal display indication or an operating problem WARNING
occurs, disconnect the AC power cord and remove the Should the CD door be opened before the reading of the CD
batteries. Wait at least 5 seconds, then reconnect the AC is completed, a jamming noise may occur. This is resolved
power cord or reinstall the batteries. by closing the CD door.
SPECIFICATIONS
CD SECTION
Channels: 2 channels
S / N ratio: 60 dB
Wow & Flutter: undetectable
Sampling frequency: 44.1 kHz 8 x over sampling
Quantization: 1 bit DA converter
Pick up light source: Semi - conductor laser
Pick up wave length 790 nm
BLUETOOTH SECTION
Bluetooth standard Bluetooth Standard Version 2.1 + EDR
Range : 10 m ( free space )
RADIO SECTION
Tuning ranges: FM 87.5 - 108 MHz
Antennas: FM Rod antenna
GENERAL
Output power: 1.5 W + 1.5 W (RMS)
Power consumption: 11 W
Aux In Jack: 3.5 MM
Phones Jack: 3.5 MM
9 GB
Speaker: 3 " 8 OHM
Power source: AC : 230V ~ 50Hz
DC : 12V ( 8 x 1.5V LR14/ "C"/UM2 )
Due to continuing improvement, the features and the design are subject to change without notice.
Where to place the item :
Today’s furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive
range of cleaning products. Therefore, the possibility that some of these substances contain components that react
adversely to the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the
appliance can cause discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface.
Hereby, Bigben Interactive SA, declares that the RCD400BT device complies with the essential requirements of the
directive 1995/5/EC of the European Parliament and of the Council of 9 March 1999 on radio equipment and telecom-
munications terminal equipment and the mutual recognition of their conformity.To download the full statement, please
visit our website: http://www.bigben-interactive.co.uk/support and the section `declaration of conformity’.
The Bluetooth® word, mark and logo are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by Bigben Interactive is under license. Other trademarks and trade names are those of their respective
owners.
Remark: In order to save energy when the unit has no sound output for a while, the unit will be switched to
stand-by automatically. It can be switched ON by using the function selector again.
10 GB