or for use by the HMI station.
The figure shows the name of the
Internet dot. Definitions as in Table 1.5-2
表1.5-2 网络 I/O 模块
Figure Name Feature Description
XNetAI Analog dot module, network
AI
XNetAO Analog Point Module, Network
AO
4 GEK-114946 OC 6000e Function
XNetDI Switch-to-do-do-module,
network DI
XNetDO Switch volume internet point
module, network DO
❑ Inter-page connection I/O module
The inter-page connection I/O module defines the variable correspondence
between the internal pages of the DPU and the page. In the figure, the
input module displays the page number (upper) and the module number
(lower) where the connected signal is located, and the output module
displays a block number in the configuration page. In addition to the
inter-page output module, the inter-page input module can refer to all
network I/O modules and hardware I/O modules, but the signal type
(analog / Switch volume) must be consistent.
When the point referenced by the inter-page input module is a hardware
I/O point or a network I/O point, a name-referenced name is displayed
on the left side of its figure. RefNotExistis displayed at the roll
call location when the referenced point does notexist.
表1.5-3 页间连接 I/O 模块
Figure Name Feature Description
XPgAI Analog Volume Inter-Page Input
Module
XPgAO Analog volume inter-page output
module
XPgDI Switch-to-page input module
XPgDO Switch-to-page output module
1.5.1.3 Text comment module
The text comment module Text is a string that the user can double-click
into the content editing interface.
1.5.2 Data type
There are three types of data passed between function blocks: Boolean
(1 byte), floating points (IEEE standard 4) bytes) and long integers
(4 bytes). However, parameters, intermediates, states, etc. are not
subject to this limitation. Floating points and long integers are
GEK-114946 OC 6000e Function 5