Scribd
Upload
70 views1 page

Screw Threads and Fastenings

This document provides instructions for drawing various screw threads and fasteners using AutoCAD software in first angle projection and at a scale of 1:1. It includes tasks to draw metric and Acme thread profiles with dimensions, show conventional representations of metric, square, and right-hand square thread types, draw a hexagonal M16 nut with rough dimensions in 3 views, and draw various nuts, bolts, washers and screws assuming an M14 size.

Uploaded by

Viba R Udupa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
70 views1 page

Screw Threads and Fastenings

This document provides instructions for drawing various screw threads and fasteners using AutoCAD software in first angle projection and at a scale of 1:1. It includes tasks to draw metric and Acme thread profiles with dimensions, show conventional representations of metric, square, and right-hand square thread types, draw a hexagonal M16 nut with rough dimensions in 3 views, and draw various nuts, bolts, washers and screws assuming an M14 size.

Uploaded by

Viba R Udupa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Screw threads and fastenings

Software: AutoCAD
First angle projection
Scale: 1:1
1. Draw Metric and Acme thread profiles using AutoCAD software. State the angle of the
thread in each case and dimension the depth, assuming a pitch of 15 mm. (20 mark)
2. Show by means of sketches, conventional methods of showing the following screw threads:
a) Metric thread, nominal diameter 12 mm.
b) Square thread, nominal 25 mm and pitch 3 mm
c) Right-hand square thread, nominal diameter 10 mm and pitch 2 mm. (15 mark)
3. Draw hexagonal nut of M16 using rough rule dimensions (3 views). (15 mark)
4. Draw following nuts, bolts, washer and screws, assume M14.
a) Cap nut (5 mark)
b) Ring nut (5 mark)
c) Plain washer (5 mark)
d) Hexagonal headed bolt (5 mark)
e) T head bolt (5 mark)
f) Stud (5 mark)
g) Set screws: Round, Countersunk, Grub screw (10 mark)
h) Lock nut(0.6D) (5 mark)
i) Castle nut (5 mark)

You might also like