Series: Question Booklet
Series: Question Booklet
Series: Question Booklet
QUESTION BOOKLET
Sr. No.
Series
Roll No. (in Figures) : _________________________________________________
Roll No. (in Words) : _________________________________________________
: 2 : 85
Time : 2 Hours Screening Test Maximum Marks : 85
PLEASE READ THIS PAGE CAREFULLY.
Note : Candidate should remove the sticker seal and
open this Booklet ONLY after announcement by
centre superintendent and should thereafter check and
ensure that this Booklet contains all the 32 pages and 32
tally with the same Code No. given at top of first page
& the bottom of each & every page. If you find any
defect, variation, torn or unprinted page, please have it
replaced at once before you start answering. 1.
IMPORTANT INSTRUCTIONS :
1. The Answer sheet of a candidate who does not
write his Roll No., or writes an incorrect Roll No.
on the title page of the Booklet and in the space
provided on the Answer sheet will neither be 2. 170
evaluated nor his result declared. 3.
2. The paper contains 170 questions.
3. Attempt all questions as there will be no Negative 4.
Marking.
4. The questions are of objective type. Here is an
example. Question : 8 Taj Mahal was built by_____
(A) Sher Shah (B) Aurangzeb
(C) Akbar (D) Shah Jahan
The correct answer of this question is Shah Jahan.
You will therefore darken the circle with ink pen
below column (D) as shown below : A B C D
A B C D Q.8
Q.8 5.
5. Each question has only one correct answer. If you
give more than one answer, it will be considered
wrong and it will not be evaluated. Changing,
cutting, overwriting and erasing of an answer
will be treated as wrong answer.
6.
6. The space for rough work wherever provided may
be utilized by the candidate. You are not to use any
portion of the Answer Sheet for rough work.
7. Do not mutilate this booklet in any manner. Serious 7.
damage/mutilation may entail disqualification.
8. Do not leave your seat until the Answer Sheets have 8.
been collected at the close of the examination.
9. Candidate will not leave the examination room till 9.
stipulated time is over and only after he has
handed over the Answer Sheet to the staff on
duty.
21. The resultant of the two forces P and Q is R. If Q is doubled, the new
resultant is perpendicular to P. Then
(A) P = Q (B) Q = R (C) Q = 2R (D) None of these
P Q R Q , P
- :
(A) P = Q (B) Q = R (C) Q = 2R (D)
23. The specific gravity of a liquid having viscosity 0.06 poise and kinematic
viscosity 0.025 stokes is :
(A) 2.4 (B) 3.4 (C) 4.4 (D) None of these
0.06 0.025
:
(A) 2.4 (B) 3.4 (C) 4.4 (D)
24. To avoid correction for capillary action in monometers used for measuring
pressures, minimum dia. of tube should be :
:
(A) 2.5 mm (B) 10 mm (C) 50 mm (D) 6 mm
65. For a simply supported beam of span 15 m, the minimum effective depth to
satisfy the vertical deflection limits should be
(A) 600 mm (B) 750 mm (C) 900 mm (D) more than 1 m.
15 m ,
(A) 600 mm (B) 750 mm (C) 900 mm (D) 1 m
67. An RCC slab under mild exposure condition having main longitudinal
tensile reinforcement of diameter 12 mm, then minimum allowable nominal
cover to satisfy durability requirements as per code (IS 456 – 2000) is
RCC 12 mm
(IS 456 – 2000)
(A) 10 mm (B) 15 mm (C) 20 mm (D) 25 mm
68. The ratio of permissible shear stress in Limit state Method of Design and
Working stress method of design is
(A) 25 : 16 (B) 5 : 4 (C) 16 : 25 (D) 4 : 5
Code No. : C-502/2018/Series-A 14
69. Minimum shear reinforcement in beams is provided in the form of stirrups to
(A) Resist extra shear force due to live load
(B) Resist the effect of shrinkage of concrete
(C) Resist principal tension
(D) Resist shear cracks at bottom of the beam
(A)
(B)
(C)
(D)
70. The main reason for providing number of reinforcing bars at a support in a
simply supported beam is to resist in that zone
(A) Compressive stresses (B) Shear stresses
(C) Bond stresses (D) Tensile stresses
__________
(A) (B)
(C) (D)
71. The reduction co-efficient of an RCC column with an effective length of 4.8
m and size 250 mm 300 mm is
RCC , 4.8 m 250 mm 300 mm ,
(A) 0.80 (B) 0.85 (C) 0.90 (D) 0.95
72. What is the minimum nominal percentage longitudinal reinforcement to be
provided in a concrete pedestal as per code ?
?
(A) 0.4 (B) 0.2 (C) 0.15 (D) 0.1
73. When minimum eccentricity in columns does not exceed 0.05 times the
lateral dimensions, the axial load carrying capacity is reduced by
0.05 ,
(A) 8% (B) 11% (C) 14% (D) 20%
15 Code No. : C-502/2018/Series-A
74. In the Limit state design of prestressed concrete structures, the strain
distribution is assumed to be
(A) Linear (B) Non-linear
(C) Parabolic (D) Parabolic and Rectangular
,
(A) (B)
(C) (D)
75. As per IRC the slope of cutting in earth should be
IRC
(A) 1 : 1 (B) 1 : 2 (C) 1 : 4 (D) 2 : 3
76. For a water bound macadam road, the recommended camber is
(A) 1 in 24 To 1 in 30 (B) 1 in 30 To 1 in 48
(C) 1 in 60 To 1 in 80 (D) 1 in 80 To 1 in 120
,
(A) 1 in 24 1 in 30 (B) 1 in 30 1 in 48
(C) 1 in 60 1 in 80 (D) 1 in 80 1 in 120
77. While performing Attrition and Los Angels abrasion test the weight of
stones to be used should be
(A) 5 kg (B) 2 kg (C) 8 kg (D) 7.5 kg
78. Mandatory signs are displaced on a disc having a diameter of
________
(A) 30 cm (B) 60 cm (C) 50 cm (D) 100 cm
79. In a tack coat, bitumen is used at the rate of
(A) 1 kg/m2 (B) 0.5 kg/m2 (C) 5 kg/m2 (D) 10 kg/m2
80. Carpeting is
(A) Smoothening of a road surface
(B) Laying of red carpet on road
(C) Laying of bitumen or concrete layer on a road
(D) Operation of removing snow from road
(A)
(B)
(C)
(D)
90. Which of the following rollers is suitable for soil cement stabilized road
construction ?
(A) Vibratory roller
(B) Sheep foot roller
(C) Pneumatic roller
(D) Smooth wheel roller
?
(A) (B) (C) (D)
Code No. : C-502/2018/Series-A 18
91. The force in the member BC of the truss as shown below is
156. ‘A’ is the brother of ‘B’. ‘B’ is the daughter of ‘C’ and ‘D’ is the father of
‘A’. Then, how is ‘C’ related to ‘D’ ?
(A) Husband (B) Wife
(C) Grand-daughter (D) Grand-father
‘A’, ‘B’ ‘B’, ‘C’ ‘D’, ‘A’ ‘C’, ‘D’
?
(A) (B) (C) (D)
157. The capital of the Jaswan state was at
(A) Jasur (B) Rajpura (C) Nadaun (D) None of these
?
(A) (B) (C) (D)
158. Shimla was the headquarters of the exiled government from 1942-1945 of
(A) Afghanistan (B) Burma (C) Tibet (D) Bangladesh
1942-1945 ?
(A) (B) (C) (D)
159. Which Sect of Buddhism is widely followed in Himachal Pradesh ?
(A) Hinayana (B) Mahayana (C) Pitambara (D) Vajrayana
?
(A) (B) (C) (D)
160. The first ever Women Polytechnic Institute of Himachal Pradesh is located at
(A) Nahan (B) Kandaghat (C) Arki (D) Jubbal
(A) (B) (C) (D)
Code No. : C-502/2018/Series-A 30
161. Which social networking giant has partnered with National Commission for
Women to offer digital literacy programme for women ?
(A) Skype (B) Facebook (C) Twitter (D) LinkedIn
?
(A) (B) (C) (D)
162. Which state government has recently declared official symbols for the State ?
(A) Telangana (B) Mizoram (C) Tripura (D) Andhra Pradesh
?
(A) (B) (C) (D)
163. The book ‘Straight Talk’ has been authored by
(A) Manmohan Singh (B) M. Venkaiah Naidu
(C) Abhishek Manu Singhvi (D) Shashi Tharoor
‘ ’ ?
(A) (B) .
(C) (D)
164. The 2018 International Dance Day was observed on which date ?
(A) 27 April (B) 28 April (C) 29 April (D) 30 April
2018 ?
(A) 27 (B) 28 (C) 29 (D) 30
165. Meaning of the idiom ‘Knit one’s brows’ is
(A) to disappoint somebody (B) to frown
(C) to have a headache (D) to express discontentment
166. Antonym of the word ‘Wizard’ is
(A) Crook (B) Magician (C) Ordinary (D) Villain
167. One must try _______ best to achieve success.
(A) his (B) her (C) one’s (D) their
168. ‘’
(A) (B) (C) (D)
169.
(A) (B) (C) (D)
170. ‘ ’
(A) (B) (C) (D)
______________
31 Code No. : C-502/2018/Series-A
Space For Rough Work /