Scribd
Upload
45 views2 pages

418-01 Module Configuration 2010 F-150 General Procedures: Procedure Revision Date: 03/19/2010

Uploaded by

argemiro montaño
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
45 views2 pages

418-01 Module Configuration 2010 F-150 General Procedures: Procedure Revision Date: 03/19/2010

Uploaded by

argemiro montaño
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

12/1/2021 2010 F-150

418-01 Module Configuration 2010 F-150


GENERAL PROCEDURES Procedure revision date: 03/19/2010

Programmable Module Installation (PMI)

Special Tool(s)
Vehicle Communication Module (VCM) and
Integrated Diagnostic System (IDS) software with
appropriate hardware, or equivalent scan tool

Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module
is Available

NOTE: Following module installation, some modules require a separate procedure be carried out. For instructions, refer to
the specific module removal and installation procedures.

1. Connect the IDS and identify the vehicle as normal.

2. From the Toolbox icon, select Module Programming and press the check mark.

3. Select Programmable Module Installation.

4. Select the module that is being replaced.

5. Follow the on-screen instructions, turn the ignition key to the OFF position, and press the check mark.

6. Install the new module and press the check mark.

7. Follow the on-screen instructions, turn the ignition key to the ON position, and press the check mark.

8. The IDS downloads the data into the new module and displays Module Configuration Complete.

9. Test module for correct operation.

Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module
is NOT Available

NOTE: Following module installation, some modules require a separate procedure be carried out. For instructions, refer to
the specific module removal and installation procedures.

1. Install the new module.

2. Connect the IDS and identify the vehicle as normal.

3. From the Toolbox icon, select Module Programming and press the check mark.

4. Select Programmable Module Installation.

5. Select the module that was replaced.

6. Follow the on-screen instructions, turn the ignition key to the OFF position, and press the check mark.

7. Follow the on-screen instructions, turn the ignition key to the ON position, and press the check mark.

8. If the data is not available, the IDS displays a screen stating to contact the As-Built Data Center. Retrieve the data
from the technician service publication website at this time and press the check mark.

9. Enter the module data and press the check mark.

10. The IDS downloads the data into the new module and displays Module Configuration Complete.
https://www.fordtechservice.dealerconnection.com 1/2
12/1/2021 2010 F-150
11. Test module for correct operation.
© Copyright 2021, Ford Motor Company.

https://www.fordtechservice.dealerconnection.com 2/2

You might also like