Scribd
Upload
91 views4 pages

Disassembly & Reassembly

This section provides instructions for disassembling and reassembling a monitor. It lists 11 steps for disassembly, including turning off the monitor, removing cables, and detaching various internal components like the LVDS cable, lamp wire, function wires, speaker, and circuit boards. A warning is given about electrostatic discharge, and cautions include not using metal tools and removing screws before detaching parts. Reassembly is noted to follow the disassembly steps in reverse order.

Uploaded by

vivija
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
91 views4 pages

Disassembly & Reassembly

This section provides instructions for disassembling and reassembling a monitor. It lists 11 steps for disassembly, including turning off the monitor, removing cables, and detaching various internal components like the LVDS cable, lamp wire, function wires, speaker, and circuit boards. A warning is given about electrostatic discharge, and cautions include not using metal tools and removing screws before detaching parts. Reassembly is noted to follow the disassembly steps in reverse order.

Uploaded by

vivija
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

3.

Disassembly and Assembly

3. Disassembly and Assembly


This section describes the disassembly and reassembly sequences for this monitor.
Warning: As this monitor has parts that are sensitive to static electricity, be careful when handling them.

3-1. Disassembly
Caution: 1. Turn the monitor off before beginning the disassembly process.
2. When disassembling the monitor, do not use any metal tools except for the provided jig.
3. Remove the signal cable and the power cord before beginning the disassembly.

Description Photo Screws


1. Place the monitor face downwards on a soft
blanket or cushion as shown in the picture on
the right. Move the stand from side to side to
disassemble it.

Caution : Do not disassemble with excessive


force. This may break the transparent
stand-bar.

2. Remove the two (2) screws at the bottom.

3-1
3. Disassembly and Assembly

Description Photo Screws


3. Hold the Front-Cover by its corners and push
it downwards. In the same manner, push down
on the other corners, lift the Rear-Cover, and
disassemble it as shown in the picture below.

3-2
3. Disassembly and Assembly

Description Photo Screws


4. After disassembling the Rear-Cover, prepare for
the internal disassembly as shown in the picture
on the right.

LVDS

LAMP WIRE

Function &
SPK Wire

5. Remove the LVDS cable.

6. Remove the Lamp wire.

7. Remove the Function & SPK wires.

3-3
3. Disassembly and Assembly

Description Photo Screws


8. Remove the SPK upwards.

9. Remove the Assy Shield-Cover.


Disassemble the PCB inside the Assy.

10. Remove the Holder-Boss from the Assy Front-


Cover.

Caution : It is difficult disassembling the panel


without removing the screws.
Make sure to remove the screws before
removing the Holder-Boss.

11. Disassemble the panel.

※ Reassembly procedures are in the reverse order of disassembly procedures.

3-4

You might also like