Scribd
Upload
198 views1 page

Infrared Anti-Collision Device: Speed-O-Controls Pvt. LTD

This document describes an infrared anti-collision device for overhead cranes. The device uses infrared emitters and reflectors to detect the presence of nearby cranes and activates an alarm or reduces speed to avoid collisions. It has adjustable sensing distances from 1 to 3 meters or 3 to 10 meters. The device incorporates a microcontroller and has two potential free relays to interface with crane controls. It is installed by mounting the emitter on one crane and reflector on the other, and connecting the relay outputs to the crane controls.

Uploaded by

Chandramohan Murugan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
198 views1 page

Infrared Anti-Collision Device: Speed-O-Controls Pvt. LTD

This document describes an infrared anti-collision device for overhead cranes. The device uses infrared emitters and reflectors to detect the presence of nearby cranes and activates an alarm or reduces speed to avoid collisions. It has adjustable sensing distances from 1 to 3 meters or 3 to 10 meters. The device incorporates a microcontroller and has two potential free relays to interface with crane controls. It is installed by mounting the emitter on one crane and reflector on the other, and connecting the relay outputs to the crane controls.

Uploaded by

Chandramohan Murugan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Infrared Anti-Collision Device

Introduction
The anti-collision system is a safety device to avoid collision of
two electric overhead traveling cranes on the same bay. The
system works on the principle of retro-reflective infrared
waves.
The system comprises of an emitter cum receiver module and
a reflector. The emitter continuously emits infrared waves in
the direction of the reflector. The waves are reflected back to
the receiver end of the system which activates an alarm signal
and stops/reduce the speed of the crane. If two cranes are away
from each other the reflected waves will not reach the sensor
and the cranes operate normally.
The advanced digital anti-collision system incorporates a
Micro-Controller Based Circuit for taking digital inputs for
easy range setting and gives an accurate cut-off range to the
device. Two sets of anti-collision systems are required for
collision avoidance between the two cranes.

Technical Specifiactions:
Micro Controller Based System
Supply Voltage
Typical Wiring Diagram
110VAC - 220VAC
Operating Temperature Upto 700C
Output Upto 2 Potential free relays
Sensing Distance (adjustable) 1 - 3 / 3 - 10 meters

Installation Procedure:
1.Mount the Transmitter/Emitter(Control Unit) on one crane as
shown in installation scheme.
2.Connect the power supply as per the connection diagram.
3.Press the laser switch and mark the point for refelctor
mounting.Mount the reflector on the second crane.
4.Smilarly follow the procedure to mount the control unit and
reflector for the other crane.
5.Connect the relay output as shown in the figure. The Anti-
Typical installation
collision device works like an LT limit switch.

Range Adjustment Setting:


1.Make sure the system is powered off.
2. For Relay 1, keeping Inc key pressed, power on the system.
For Relay 2, keeping the Shift key pressed, power on the
105

system. The display should show SET/(rl1) or SET/(rl2), then 10


show digit (d00).
3. Using the Inc. key, set the number to the distance at which
the relay should cut-off.
168
52
99

185

4. After selecting the range, press the Set key.


5.Restart the system.
Dimension Drawing
Speed-O-Controls Pvt. Ltd.
H. O. Unit -I : C-15/16, Nand Jyot Unit - II: Plot No. 4912, G. I. D. C.,
Industrial Estate, Andheri-Kurla Phase IV, Vatva,
Road, Mumbai - 400072 , Ahmedabad - 382445
Tel : (022) 42469700-30 Tel. : (079) 40083201/2/3/4, Visit us at :
Fax : (022) 42469797 Fax : (079) 25841056, www.speedocontrols.com
Sep 2019
E-mail : [email protected] E-mail : [email protected] www.socremote.com
V3

You might also like