Chapter 6. Capacitor and Capacitance - 1

Chapter 6.
CAPACITORS and CAPACITANCE
6.1. CAPACITOR
Figure 6.1 represents two parallel metal plates, A and B, charged
to different potentials
Figure 6.1
If an electron that has a negative charge is placed between the

plates, a force will act on the electron tending to push it away
from the negative plate B towards the positive plate, A. Similarly,
a positive charge would be acted on by a force tending to move it
toward the negative plate.
Prepared by Surya Hardi, Ph.D 1
Two parallel conducting plates separated from each other by air.
They are connected to opposite terminals of a battery of voltage V
volts.
Figure 6.2

Electric lines of force (often called
electric flux lines)

6.2 Capacitance
The presence of the field indicates the presence of equal positive and
negative electric charges on the two plates of Fig. 6.2. Let the charge
be CQ coulombs on one plate and Q coulombs on the other.
farad F

6.3 Electric flux density
Thus electric flux is measured in coulombs, and for a charge of Q
coulombs, the flux ѱ = Q coulombs.
Electric flux density is also called charge density,

.
6.4 Permittivity
For a field established in vacuum (or for practical purposes in air),
the ratio D/E is a constant ε0, i.e.

For insulating medium, such as mica, paper, plastic or ceramic,
the ratio of D/E is modified,
where εr, the relative permittivity of the insulating material,

indicates its insulating power compared with that of vacuum:
and

Exercise: Problems on capacitors and capacitance
1. Find the charge on a 10 μF capacitor when the applied voltage is

250V [2.5mC]. Determine the voltage across a 1000 pF capacitor
to charge it with 2 μC. [2 kV]
2. The charge on the plates of a capacitor is 6mC when the potential
between them is 2.4 kV. Determine the capacitance of the
capacitor. [2.5 μF]
3. For how long must a charging current of 2A be fed to a 5 μF
capacitor to raise the p.d. between its plates by 500 V. [1.25ms]
4. A direct current of 10A flows into a previously uncharged 5 μF
capacitor for 1ms. Determine the p.d. between the plates. [2 kV]
5. A 16μF capacitor is charged at a constant current of 4 μA for
2min. Calculate the final p.d. across the capacitor and the
corresponding charge in coulombs. [30V, 480 μC]
6. A steady current of 10A flows into a previously uncharged
capacitor for 1.5ms when the p.d. between the plates is 2 kV. Find
the capacitance of the capacitor. [7.5 μF]
Problem. Two parallel plates having a p.d. of 200V between them
are spaced 0.8mm apart. What is the electric field strength? Find
also the electric flux density when the dielectric between the plates
is (a) air, and (b) polythene of relative permittivity 2.3.

1. A two-plate capacitor has a charge of 25 C. If the effective area
of each plate is 5 cm2 find the electric flux density of the
electric field. [50 kC/m2]
2. A charge of 1.5 μC is carried on two parallel rectangular plates
each measuring 60mm by 80 mm. Calculate the electric flux
density. If the plates are spaced 10mm apart and the voltage
between them is 0.5 kV determine the electric field strength.
[312.5 μC/m2, 50 kV/m].
3. The electric flux density between two plates separated by
polystyrene of relative permittivity 2.5 is 5 μC/m2. Find the
voltage gradient between the plates. [226 kV/m]

6.4 The parallel plate capacitor
Capacitance C is proportional to the area A of a plate, inversely

proportional to the plate spacing d

Problem. (a) A ceramic capacitor has an effective plate area of 4
cm2 separated by 0.1mm of ceramic of relative permittivity 100.
Calculate the capacitance of the capacitor in picofarads. (b) If the
capacitor in part (a) is given a charge of 1.2 μC what will be the
p.d. between the plates?

6.4 Capacitors connected in parallel and series
for n parallel-connected capacitors

(b) Capacitors connected in series
In a series circuit:

Special case of two capacitors in series

Problem. What capacitance must be connected in series with a 30
μF capacitor for the equivalent capacitance to be 12 μF?
Solution

Problem. Capacitance’s of 1 μF, 3 μF, 5 μF and 6μF are connected in
parallel to a direct voltage supply of 100 V. Determine (a) the
equivalent circuit capacitance, (b) the total charge and (c) the
charge on each capacitor.
Solution:
(a) The equivalent capacitance C for four capacitors in parallel is
given by

Problem. Capacitance’s of 3 μF, 6 μF and 12 μF are connected in
series across a 350V supply. Calculate (a) the equivalent circuit
capacitance, (b) the charge on each capacitor, and (c) the p.d.
across each capacitor.

6.5 Energy stored in capacitors
The energy, W, stored by a capacitor is given by
Problem. A capacitor is charged with 10 mC. If the energy stored is

1.2 J find (a) the voltage and (b) the capacitance.

6.5 Discharging capacitors
When a capacitor has been disconnected from the supply it may

still be charged and it may retain this charge for some considerable
time.
The capacitor is automatically discharged after the supply is
switched off. This is done by connecting a high value resistor
across the capacitor terminals.

Chapter 6. Capacitor and Capacitance - 1

Uploaded by

Copyright:

Available Formats

Chapter 6. Capacitor and Capacitance - 1

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Chapter 6. Capacitor and Capacitance - 1

Uploaded by

Copyright:

Available Formats

Chapter 6.

CAPACITORS and CAPACITANCE

If an electron that has a negative charge is placed between the

Prepared by Surya Hardi, Ph.D 2

Prepared by Surya Hardi, Ph.D 3

Prepared by Surya Hardi, Ph.D 4

Electric flux density is also called charge density,

Prepared by Surya Hardi, Ph.D 5

where εr, the relative permittivity of the insulating material,

Prepared by Surya Hardi, Ph.D 6

1. Find the charge on a 10 μF capacitor when the applied voltage is

Prepared by Surya Hardi, Ph.D 8

Prepared by Surya Hardi, Ph.D 9

Capacitance C is proportional to the area A of a plate, inversely

Prepared by Surya Hardi, Ph.D 10

Prepared by Surya Hardi, Ph.D 11

for n parallel-connected capacitors

Prepared by Surya Hardi, Ph.D 12

Prepared by Surya Hardi, Ph.D 13

Prepared by Surya Hardi, Ph.D 14

Prepared by Surya Hardi, Ph.D 15

Prepared by Surya Hardi, Ph.D 16

Prepared by Surya Hardi, Ph.D 18

The energy, W, stored by a capacitor is given by

Problem. A capacitor is charged with 10 mC. If the energy stored is

Prepared by Surya Hardi, Ph.D 20

When a capacitor has been disconnected from the supply it may

Prepared by Surya Hardi, Ph.D 22

You might also like