Scribd
Upload
82 views5 pages

Universal Car Emulator Programs:: Program Use

This document provides instructions for using a universal car emulator program called "Daewoo 1". It can be used with ECUs that have either a white-red socket or a blue socket. For the white-red socket ECU, the emulator must be modified by writing values to address 010 of the Motorola HC11F1 processor twice. For the blue socket ECU, the same modification is made. For both, the emulator is then connected to the ECU and insulation tape is used. The original immobilizer must also be disconnected. If starting problems occur, disconnecting the ECU's power supply and connecting the ACC line may help.

Uploaded by

david
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
82 views5 pages

Universal Car Emulator Programs:: Program Use

This document provides instructions for using a universal car emulator program called "Daewoo 1". It can be used with ECUs that have either a white-red socket or a blue socket. For the white-red socket ECU, the emulator must be modified by writing values to address 010 of the Motorola HC11F1 processor twice. For the blue socket ECU, the same modification is made. For both, the emulator is then connected to the ECU and insulation tape is used. The original immobilizer must also be disconnected. If starting problems occur, disconnecting the ECU's power supply and connecting the ACC line may help.

Uploaded by

david
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

1

Back to Main Page

Universal Car Emulator Programs:


Daewoo 1 ........................................................................................................................... 3

Program Use
• ECU with white – red socket
Daewoo 1
• ECU with blue socket

Wiring colour codes

The LED behavior

- no jumpers – diagnostic mode - it flashes every second

- adjusting to the ECU – flashing 0,1 sec

- after adjusting it lights constantly and blinks every other second


2

Back to Main Page

Daewoo 1

In Universal Emulator
solder jumpers J1, J2 and J3

USE

ECUs with white - red sockets and ECUs with blue sockets
3

Back to Main Page


Darewoo 1

ECU with white – red socket


This emulator requires modification of Motorola HC11F1 processor located in ECU.

In address 010 write value 73 00 73 00


twice

Once you modified Motorola, connect


emulator to the ECU as pictured.

Before connecting the emulator, it


must be precisely insulated with
insulation tape and the original
immobiliser must be disconnected!!!

In case of problems with starting the car,


disconnect power supply (+12V) in ECU
and connect +12V ACC in place of
power supply.
4

Back to Main Page


Darewoo 1

ECU with blue socket

This emulator requires modification of Motorola HC11F1 processor located in ECU

In address 010, write value 73 00 73 00 twice

Once you modified Motorola, connect emulator to the ECU as pictured.


5

Back to Main Page


Darewoo 1

Disconnect immo or cut off pin B7 from ECU

Before connecting the emulator, it must be precisely insulated with insulation tape and the
original immobiliser must be disconnected!!!

In case of problems with starting the car, disconnect power supply (+12V) in ECU and connect
+12V ACC in place of power supply.

You might also like