Scribd
Upload
104 views3 pages

HW 10

Uploaded by

Miles Grubbs
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
104 views3 pages

HW 10

Uploaded by

Miles Grubbs
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

HW 10

17. Find VCE, VBE, and VCB in both circuits of Figure 4– 55.

Figure 4– 55

18. Determine whether or not the transistors in Figure 4– 55 are saturated.


20. Determine the terminal voltages of each transistor with respect to ground for each circuit in
Figure 4– 57. Also determine VCE, VBE, and VCB.

Figure 4– 57

21. If the βDC in Figure 4– 57( a) changes from 100 to 150 due to a temperature increase, what is
the change in collector current?
22. A certain transistor is to be operated at a collector current of 50 mA. How high can VCE go
without exceeding a PD( max) of 1.2 W?

23. The power dissipation derating factor for a certain transistor is 1 mW/° C. The PD( max) is
0.5 W at 25° C. What is PD( max) at 100° C?

Section 4– 4 The BJT as an Amplifier


25. To achieve an output of 10 V with an input of 300 mV, what voltage gain is required?

26. A 50 mV signal is applied to the base of a properly biased transistor with r’e = 10 Ω and RC =
560 Ω. Determine the signal voltage at the collector.

Based upon:
FLOYD, THOMAS L., ELECTRONIC DEVICES (CONVENTIONAL CURRENT VERSION), 9th Ed., © 2012. Reprinted by
permission of Pearson Education, Inc., Upper Saddle River, NJ.

You might also like