LA AN NY YA AR RD D P PU UL LLR LRO OP PE E: Lanyard Pull Rope

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

LANYAR D

PULL RO
ROPE
STL-10-V

Made in Western Australia

Vectran™ is a UV Stable Red Polyurethane coated LCP (Liquid Crystal Polymer) 3mm
ID x 5mm OD multifilament melt spun yarn rope, designed and manufactured for the purpose of a lanyard emergency
stop pull wire system.
is designed to comply with the Machinery Standards AS 4024.3610 2015 Clause
2.10.6.1 Pull wire emergency stops, general (Pull wires should be coloured red) and 2.10.6.2 (e) Materials used
are of adequate strength, protected against environmental conditions and suitable for handling without additional
protection being worn by operators. Note: if the environment the pull wire is located in may cause visual loss of
it’s location then consideration should be given to add additional notification via reflective signs at no more than
30m intervals. See STP-ES, STG-ES or STL-ES.
The Actuator of a Lanyard switch is the Pull Wire thus it is made in a Red UV stable Polyurethane so to with stand
the harsh environments that the wires are placed in, without cracking of the cover or fading of the colour. Once the
is fitted to a Lanyard Switch and run through
rope guides and installed as per the switch Installation Instruction, you will then make sure your site is complying to
the relevant Australian or International Standards for conveyor Emergency Stops.
STL-10-V is over 5 times lighter than STL-10-SS. This reduces the wear of the outer coating by having less weight
resting on the guides, plus helps relieve static friction between the two. This makes pull parameters and activations of
lanyards more effective and safer. STL-10-V has zero stretch when in a lanyard rope tension situation, however STL-
10-SS has slight stretch over time. STL-10-V has low coefficient of thermal expansion and contraction. STL-10-V
is a set and forget pull wire with no climate change adjustment needed as found sometimes with STL-10-SS. Vectran
being five times stronger than steel and having a coating that is UV stable and very tough to cut, the STL-10-V is
fit for the purpose as a lanyard pull wire.

LANYARD PULL ROPE


LA N YA R D PULL ROPE
STL-10-V
Part No.
Part No. STG-200-SS STP-ES, STG-ES or STL-ES
Part No. STP-E60

EMERGENCY
STOP

TECHNICAL SPECIFICATIONS
Diameter Jacketed Internal Diameter Weight Jacketed rope Outer Coating Break Strength
5mm 3mm 21.6kg/km PU Red 9.3 kN min. 478kgf

Vectran™ is a high performance multifilament yarn spun from liquid crystal polymer (LCP). Vectran™ is the only
commercially available melt spun LCP fiber in the world. Vectran™ fiber exhibits exceptional strength and rigidity.
Pound for pound Vectran™ fiber is five times stronger than steel and ten times stronger than aluminium. These
unique properties characterize Vectran™:
• High Strength and modulus • Low coefficient of thermal expansion (CTE)
• Excellent creep resistance • High dielectric strength
• High abrasion resistance • Outstanding cut resistance
• Excellent flex/fold characteristics • Excellent property retention at high/low temperatures
• Minimal moisture absorption • Outstanding vibration damping characteristics
• Excellent chemical resistance • High impact resistance

COMPARISON OF PROPERTIES OF VARIOUS ENGINEERING MATERIALS


Material Density Tensile Specific Tensile Specific
(g/cm3) Strength Strength Modules Modules
Vectran™ 1.41 3.2 229 75 5300
Titanium 4.5 1.3 29 110 2500
Stainless Steel 7.9 2.0 26 210 2700
Aluminium 2.8 0.6 22 70 2600
E-Glass 2.6 3.4 130 72 2800
Graphite (AS4) 1.8 4.3 240 230 13000

THERMAL PROPERTIES
• Good LOI (equivalent to aramids) and low smoke generation
• Low thermal shrinkage (hot air, boiling water and laundry
• No dripping in vertical flammability tests
• Good strength retention after hot air and radiant energy exposures
• Low, negative coefficient of thermal expansion
• Excellent property retention in a broad temperature range
• No measurable volatile condensable mass (VCM) and 0.3% maximum weight loss (TML or TWL) in testing for
aerospace applications. (See also "Offgassing/outgassing")).

ORDERING DETAILS
Part No Description

STL -10 - V 3mm ID x 5mm OD Vectran™ Red UV Stable Polyurethane Coated Rope
DEL: CB007A 08/18

Manufactured in Sold by:


Australia by:

18 Tambrey Way, Malaga


Western Australia 6090
PUB. No. STL

Telephone: (08) 9247 6700


Facsimile: (08) 9248 6292 www.safe-t-products.com.au

You might also like