Scribd
Upload
150 views

Goal. Use The Provided PKT File and Configure The Following

The document provides instructions for configuring Rapid PVST, VLANs, trunk ports, root bridges, and IP addresses on switches and PCs in a network using a PKT file. The goals are to configure the hostname and Rapid PVST on all switches, assign access interfaces and VLANs with PortFast, configure trunk interfaces, designate root switches by VLAN, and add VLANs manually on each switch. The configuration is then saved as a file for the STP exercise.

Uploaded by

Ade Nurjaman
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
150 views

Goal. Use The Provided PKT File and Configure The Following

The document provides instructions for configuring Rapid PVST, VLANs, trunk ports, root bridges, and IP addresses on switches and PCs in a network using a PKT file. The goals are to configure the hostname and Rapid PVST on all switches, assign access interfaces and VLANs with PortFast, configure trunk interfaces, designate root switches by VLAN, and add VLANs manually on each switch. The configuration is then saved as a file for the STP exercise.

Uploaded by

Ade Nurjaman
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

CYBER QUINCE

Udemy

Goal. Use the provided PKT file and configure the following:

1. Hostname according to the diagram and Rapid PVST on all switches.


2. Access interfaces and VLANs – 8 interfaces per VLAN + PortFast.
3. Trunk interfaces.
4. Configure Root switches according to the diagram.
5. IP addresses on PCs.
6. Save the PKT file now, as “STP exercise without VTP.pkt”
7. Add all VLANs on all switches manually.

1. Hostname and Rapid PVST

Switch(config)#hostname S1
Switch(config)#spanning-tree mode rapid-pvst

2. Access + PortFast

S1(config)#interface range FastEthernet 0/1-8


S1(config-if-range)#switchport mode access
S1(config-if-range)#switchport access vlan 10
S1(config-if-range)# spanning-tree portfast

S1(config)#interface range FastEthernet 0/9-16


S1(config-if-range)#switchport mode access
S1(config-if-range)#switchport access vlan 20
S1(config-if-range)# spanning-tree portfast

3. Trunk

S1(config)#interface range GigabitEthernet 0/1-2


S1(config-if-range)#switchport mode trunk
CYBER QUINCE
Udemy

S1(config)#interface FastEthernet F0/24


S1(config-if-range)#switchport mode trunk
…

4. Root Bridge

S1(config)# spanning-tree vlan 10 root primary


S3(config)# spanning-tree vlan 20 root primary
S5(config)# spanning-tree vlan 30 root primary

5. PC IPs

PC -> Desktop -> IP Configuration -> allocate addresses according to the diagram

6. Save the file as “STP exercise without VTP.pkt”

7. Add VLANs manually

S1(config)#vlan 30
S2(config)#vlan 20
S4(config)#vlan 10
S5(config)#vlan 10
S5(config)#vlan 20
S5(config)#vlan 30
S6(config)#vlan 10
S6(config)#vlan 20

You might also like