Scribd
Upload
1K views3 pages

SRAM Data Save Operation On DPL/MDI

The document provides instructions for saving data on a FANUC DPL/MDI controller using SRAM or RS232. It describes pressing button combinations like (0) and (.) to save data to addresses 6 and 7 using SRAM. It also lists the RS232 channel and baud rate settings needed to save data via an I/O channel using RS232 communication.

Uploaded by

Wazabi Moo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views3 pages

SRAM Data Save Operation On DPL/MDI

The document provides instructions for saving data on a FANUC DPL/MDI controller using SRAM or RS232. It describes pressing button combinations like (0) and (.) to save data to addresses 6 and 7 using SRAM. It also lists the RS232 channel and baud rate settings needed to save data via an I/O channel using RS232 communication.

Uploaded by

Wazabi Moo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

FANUC data save Operation on DPL/MDI

***SRAM data save Operation on DPL/MDI

1. pressing the ( 0 ) and ( . ) it same 6 and 7 on CRT


2. pressing the ( 1 ) and ( . ) it same 1 and 7 on CRT

pressing the pressing the


(0) and (.) or
(1) and (.) ( )

FANUC

FANUC THAI LIMITED Page 1／3


Design by : Jaturong S. FA Division 17/09/2020
***Data save Operation on DPL/MDI by RS232

1. RS232 setting on DPL/MDI

I/O channel = 0

I/O channel = 1

Baud rate for I/O channel = 0

Baud rate for I/O channel = 1

Baud rate for I/O channel

FANUC

FANUC THAI LIMITED Page 2／3


Design by : Jaturong S. FA Division 17/09/2020
2. Select mode and setting according to the table

FANUC

FANUC THAI LIMITED Page 3／3


Design by : Jaturong S. FA Division 17/09/2020

You might also like