0% found this document useful (0 votes)
102 views4 pages

Arduino - Blinking LED: Components Required

This document provides instructions for blinking an LED with an Arduino board. It is described as the "Hello World" of microcontrollers. The components and circuit required are listed, including an Arduino Uno, LED, resistor, and jumper wires. The circuit diagram and code are provided to blink the LED on and off with a one second delay between states. Key aspects of the code are explained, such as using pinMode() to set a pin as an output and digitalWrite() to set the pin high or low voltage.

Uploaded by

Steve Clar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
102 views4 pages

Arduino - Blinking LED: Components Required

This document provides instructions for blinking an LED with an Arduino board. It is described as the "Hello World" of microcontrollers. The components and circuit required are listed, including an Arduino Uno, LED, resistor, and jumper wires. The circuit diagram and code are provided to blink the LED on and off with a one second delay between states. Key aspects of the code are explained, such as using pinMode() to set a pin as an output and digitalWrite() to set the pin high or low voltage.

Uploaded by

Steve Clar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Arduino - Blinking LED

LEDs are small, powerful lights that are used in many different applications. To start,
we will work on blinking an LED, the Hello World of microcontrollers. It is as simple as
turning a light on and off. Establishing this important baseline will give you a solid
foundation as we work towards experiments that are more complex.

Components Required
You will need the following components −

 1 × Breadboard
 1 × Arduino Uno R3
 1 × LED
 1 × 330Ω Resistor
 2 × Jumper

Procedure
Follow the circuit diagram and hook up the components on the breadboard as shown in
the image given below.

Note − To find out the polarity of an LED, look at it closely. The shorter of the two legs,
towards the flat edge of the bulb indicates the negative terminal.
Components like resistors need to have their terminals bent into 90° angles in order to
fit the breadboard sockets properly. You can also cut the terminals shorter.

Sketch
Open the Arduino IDE software on your computer. Coding in the Arduino language will
control your circuit. Open the new sketch File by clicking New.
Arduino Code
/*
Blink
Turns on an LED on for one second, then off for one second,
repeatedly.
*/

// the setup function runs once when you press reset or power the
board

void setup() { // initialize digital pin 13 as an output.


pinMode(2, OUTPUT);
}

// the loop function runs over and over again forever

void loop() {
digitalWrite(2, HIGH); // turn the LED on (HIGH is the voltage
level)
delay(1000); // wait for a second
digitalWrite(2, LOW); // turn the LED off by making the voltage
LOW
delay(1000); // wait for a second
}
Code to Note
pinMode(2, OUTPUT) − Before you can use one of Arduino’s pins, you need to tell
Arduino Uno R3 whether it is an INPUT or OUTPUT. We use a built-in “function” called
pinMode() to do this.
digitalWrite(2, HIGH) − When you are using a pin as an OUTPUT, you can command
it to be HIGH (output 5 volts), or LOW (output 0 volts).

You might also like