The document provides specifications for flat head six-lobe thread forming screws including dimensions, tolerances, materials, heat treatment details, hardness values and other technical information. Metric screw sizes range from M2.5 to M5.
The document provides specifications for flat head six-lobe thread forming screws including dimensions, tolerances, materials, heat treatment details, hardness values and other technical information. Metric screw sizes range from M2.5 to M5.
The document provides specifications for flat head six-lobe thread forming screws including dimensions, tolerances, materials, heat treatment details, hardness values and other technical information. Metric screw sizes range from M2.5 to M5.
The document provides specifications for flat head six-lobe thread forming screws including dimensions, tolerances, materials, heat treatment details, hardness values and other technical information. Metric screw sizes range from M2.5 to M5.
Flat Six-Lobe Plastite® Plas-Fix® 45° Alternative Thread Rolling Screws
G T F C D Diameter of Recommended Nominal Head Recess Measurements Minimum Pilot Hole Sizes Head Diameter Driver Circumscribing Screw Height Depth Across Center Out-Of- Size Circle Size Round Max Min Ref Min Max Min Max Min Min Max
Tolerance on Length M2 thru M5, up to 20mm: ±0.8 M2 thru M5, Over 20mm: ±1.3
Trilobular thread-rolling screw with extra wide spacing between 45° profile threads and a single lead thread that extends from Description the blunt point. The head is countersunk with a hexalobular recess for driving the crew
Applications/ Thermoplastics, engineering resins and certain thermosets. Sharper thread profile increases holding strength while reducing Advantages material displacement. Drive and strip torques are higher, reducing the need for inserts or reinforcing clips.
Steel Material AISI 1022 steel
Heat Treatment Screws shall be quenched in liquid and then tempered by reheating to 650°F minimum.
Case Hardness HV 450 minimum
M2 thru M3.5 diameters: 0.05 - 0.18 mm
Case Depth M4 & M5 diameters: 0.10 - 0.25 mm
Core Hardness HV 250 - 380 (after tempering) Plating Screws have a RoHS-compliant zinc finish.
Plastite® is a registered trademark of REMINC. Kanebridge’s screws are not authorized or made by licensed REMINC manufacturers. Plas-Fix® is a registered trademark of Lancaster Fasteners Co. Ltd.. Kanebridge’s screws are not authorized or made by licensed Lancaster Fastener manufacturers. This page prints with a watermark. 547
