Scribd
Upload
54 views1 page

Exp No 07 Temperature Sensor

Uploaded by

Manjuanth
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
54 views1 page

Exp No 07 Temperature Sensor

Uploaded by

Manjuanth
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 1
Ex. NO. 7 Temperature Sensor Aim: Conduct an experiment to measure temperature in terms of current/voltage using a ‘temperature sensor bridge Cireuit Diagram: Excitation Current Source Lead Resistance Wire “B” ‘The most common method for measuring the resistance of an RID is use a Wheatstone bridge circuit. Figure shows the arrangement for two-wire RTD. An electrical excitation current is passed through bridge, and the RTD and bridge output voltage is an indication of the RTD resistance. The circuit uses a very stable excitation power source, three high-precision resistors. that have a very low temperature _ coeffic a high-input impedance amplifier to measure the resistance change of RTD with changes in temperature. Procedure: 1. Construct the sensor bridge as shown in figure. All re 2. Immerse RTD in a beaker filled with water. Heat the water 3. Note down the temperature, error voltage and RTD resistance Tabular Column: SINo Temperature | Error Voltage Resistance( Multimeter) Electronic Devices and Instrumentation Lab - 18ECL37 rors are of 100 ohm. Page 30

You might also like