Scribd Logo
Upload

Welcome to Scribd!

  • 40 views

    Experiment 7 Lab Report

    Uploaded by

    Tasnia Yasmin
    The document describes an experiment to design and setup a differentiator circuit using an op amp. It includes the aim, objectives, required equipment, principle of operation, procedure, circuit diagram, design calculations, and graph of the input and output waveforms.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Experiment 7 Lab Report

    Uploaded by

    Tasnia Yasmin
    40 views2 pages
    The document describes an experiment to design and setup a differentiator circuit using an op amp. It includes the aim, objectives, required equipment, principle of operation, procedure, circuit diagram, design calculations, and graph of the input and output waveforms.

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    The document describes an experiment to design and setup a differentiator circuit using an op amp. It includes the aim, objectives, required equipment, principle of operation, procedure, circuit diagram, design calculations, and graph of the input and output waveforms.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    40 views2 pages

    Experiment 7 Lab Report

    Uploaded by

    Tasnia Yasmin
    The document describes an experiment to design and setup a differentiator circuit using an op amp. It includes the aim, objectives, required equipment, principle of operation, procedure, circuit diagram, design calculations, and graph of the input and output waveforms.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 2

    EEE 204

    Experiment No 7
    DIFFERENTIATOR
    Aim: To design and setup a Differentiator circuit using OP AMP 741C and plot
    their pulse response.
    Objectives: After completion of this experiment, student will be able to design and
    setup a differentiator circuit using OP AMP.
    Equipments/Components:
    Sl. No Name and Specification Quantity required
    1 Dual power supply +/- 15V 1
    2 Function generator (0- 1MHz) 1
    3 Oscilloscope 1
    4 Bread board 1
    5 IC 741C 1
    6 Resistor 1
    7 Capacitor 1
    8 Probes and connecting wires As required.

    Principle:
    It is an opamp circuit which performs the mathematical operation of
    differentiation. That is the output waveform is the derivative or differentia l of the
    input voltage. That is Vo= - RfCd(Vin)/dt. The differentiator circuit is constructed
    from basic inverting amplifier by replacing the input resistance Ri with capacitor C.
    This circuit also works as high pass filter.
    Procedure:

    1. Check the components.


    2. Setup the circuit on the breadboard and check the connections.
    3. Switch on the power supply.
    4. Keep the oscilloscope in AC coupling mode.
    5. Give Vi= 2Vpp, 1KHz square wave.
    6. Observe input and output on two channels of the oscilloscope simultaneously.
    7. Note down and draw the input and output waveforms on the graph.

    Result:
    EEE 204

    Circuit Diagram:

    Design:
    Given f =
    1 KHz
    So T =
    1/f = 1ms
    Design equation is T =
    2πRfC Let C = 0.01µF
    Then Rf = 15KΩ
    Let Ri = Rf/10 = 1.5KΩ

    Graph:

    You might also like