01-16 DTC Memory Checking PDF
Uploaded by
mefisto06c01-16 DTC Memory Checking PDF
Uploaded by
mefisto06cDTC memory, checking (function 02) and erasing (function 05) Page 1 of 4
01-16
DTC memory, checking
(function 02) and erasing
(function 05)
- Connect VAS5051 tester or VAG1551 scan tool
and select control module for engine electronics
using "address word" 01 Page 01-10 . Engine
should run at idle.
Note:
If engine doesn't start, crank engine using starter
for at least 5 seconds. Do not switch ignition off
afterward under any circumstance.
Rapid data transfer HELP When indicated on display
Select function XX
- Press buttons -0- and -2- to select "Check DTC memory" and press -Q-
button to confirm input.
No malfunction recognized When indicated on display
- Press button.
or
X malfunctions recognized! When indicated on display
When printer is switched on, stored DTCs are shown in sequence and
printed.
http://127.0.0.1:8080/audi/servlet/Display?action=Goto&type=repair&id=AUDI.B5.FU06.01.2 11/21/2002
DTC memory, checking (function 02) and erasing (function 05) Page 2 of 4
01-17
- Find printed DTCs in DTC table and repair
Page 01-19 .
Note:
If there are no DTCs in DTC memory, DTC
memory should not be unnecessarily erased or
else readiness code will be lost.
If DTC memory was erased, readiness code
must be re-generated Page 01-73 .
- Press button.
Rapid data transfer HELP When indicated on display
Select function XX
- Press buttons -0- and -5- to select "Erase DTC memory" and press -Q-
button to confirm input.
Note:
WARNING! When indicated on display
DTC memory was not checked
Procedure was not followed exactly.
- Check DTC memory.
DTC memory will not be erased under the following conditions:
Ignition switched off after DTC memory was checked.
http://127.0.0.1:8080/audi/servlet/Display?action=Goto&type=repair&id=AUDI.B5.FU06.01.2 11/21/2002
DTC memory, checking (function 02) and erasing (function 05) Page 3 of 4
A static malfunction was not repaired.
Rapid data transfer When indicated on display
DTC Memory is erased!
http://127.0.0.1:8080/audi/servlet/Display?action=Goto&type=repair&id=AUDI.B5.FU06.01.2 11/21/2002
DTC memory, checking (function 02) and erasing (function 05) Page 4 of 4
01-18
- Press button.
- Check DTC memory again after repair work and
erase it if necessary.
Note:
This causes DTCs to be erased that were stored
during repair of malfunction, e.g. because
harness connectors were disconnected.
- If DTC memory was erased, readiness code
must be re-generated Page 01-73 .
End Output
Rapid data transfer HELP When indicated on display
Select function XX
- Press buttons -0- and -6- to select "End output" and press -Q- button to
confirm input.
Rapid data transfer HELP When indicated on display
Enter address word XX
- Switch off ignition and disconnect diagnostic cable.
http://127.0.0.1:8080/audi/servlet/Display?action=Goto&type=repair&id=AUDI.B5.FU06.01.2 11/21/2002
