Scribd
Upload
38 views2 pages

Category 1. Closed-Loop Control - Analog (PID Controller)

This document describes a temperature control system using a PID controller. The system monitors and controls temperature, which can be applied to heaters and air conditioners. It includes a GUI to set the constant value and PID parameters, and a block diagram showing input from a temperature sensor, the PID controller, and output to an actuator to control temperature.

Uploaded by

Benj Mendoza
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
38 views2 pages

Category 1. Closed-Loop Control - Analog (PID Controller)

This document describes a temperature control system using a PID controller. The system monitors and controls temperature, which can be applied to heaters and air conditioners. It includes a GUI to set the constant value and PID parameters, and a block diagram showing input from a temperature sensor, the PID controller, and output to an actuator to control temperature.

Uploaded by

Benj Mendoza
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

1.

Title Page –
i. Temperature control with a PID controller
ii. Category 1 (PID Controller)
iii. Allag, Mendoza, Santiago, Villasencio

2. Project Description- describe the control system application you wish to use your GUI,
indicate which parameter to be monitored and controlled. The Temperature control
system with a PID controller is used to monitor and control temperature. This can be
used in heaters, air-conditioners and many more. Parameter that is monitored and
controlled is temperature. To simulate, A value for constant and the three values needed
for the PID controller must be set.

3. Sample GUI

4. Categories
Category 1. closed-loop control - analog (PID controller)

5. Block Diagram - indicate the input (from sensor/s) , controller, output (actuator, motor,
heater, etc)

You might also like