Dog Tennis Ball Toy Done
Dog Tennis Ball Toy Done
Dog Tennis Ball Toy Done
Tennis Ball
Step 1: Find the middle of both cords and Step 2: Bring the far left cord behind the
lay them out as shown. middle two cords then back over the third
cord. It is now the second cord.
Step 3: Bring the far right cord behind the Repeat steps 2 and 3 keeping your
middle two cords then back over the braiding tight until you have about a foot
second cord on the left. remaining on each cord.
Use a scrap piece of paracord and insert it Cut two 1 inch holes in opposite sides of
through the beginning of your braid. your tennis ball. Insert some forceps
through each hole and pinch the scrap
piece ends with tips of the forceps.
Pull the forceps until your braid comes Bring two of your ends through the top of
through both holes leaving one end about your braid creating one big loop.
six inches long. Remove the scrap piece.
Now bring the same two cords through the At this point you can weave a cobra or
braid directly across in the loop forming solomon bar over both sides of the braid
two smaller loops. to secure them. Or follow the next steps
for a crown knot.
Step 4: Bring the bottom right cord over Step 5: Cross the top right cord over the
the top right cord. previous cord, over the two braids, and
over the top left cord.
Step 6: Fold the top left cord over the Step 7: Bring the bottom left cord over the
previous cord and over the bottom left previous cord, under the two braids and
cord. down through the space created by the
first cord on the bottom right. Pull all four
cords tight.
Repeat steps 4 through 7 until you have Our dog toy measures about 15.5 inches
about two inches of knots. Then trim and from end to end and used two 10 ft pieces
melt the ends. of paracord.