Operation: USB Interface U1, U2, U3 and U4
Operation: USB Interface U1, U2, U3 and U4
Operation: USB Interface U1, U2, U3 and U4
Signaling
The LEDs of the 560HMR01 are controlled by the
560HMR01 firmware and a windows service.
Tab. 4 describes the system LEDs of the
560HMR01.
Firmware Version
This board will be delivered with Windows Em-
bedded Standard 7 with SP1 (English, 32bit).
Note:
We reserve the right to make technical changes or modify the contents of this
document without prior notice. With regard to purchase orders, the agreed par-
ticulars shall prevail. ABB AG does not accept any responsibility whatsoever for
potential errors or possible lack of information in this document.
We reserve all rights in this document and in the subject matter and illustrations
contained therein. Any reproduction, disclosure to third parties or utilization of
its contents - in whole or in parts - is forbidden without prior written consent of
ABB AG