wrc1 Wifi Stage Router v2 PDF
wrc1 Wifi Stage Router v2 PDF
LAN ports
DLNA WAN Port
DLNA analog outputs
Reset switch
The rack placement and operational environment for the WRC-1 can affect the wireless signal range and coverage.
For best results, follow these guidelines:
• Mount the WRC-1 near the top of the rack and away from any other gear that may use radio waves in the
same 2.4 GHz or 5 GHz range. Note that rack-mount computers or laptops placed directly above the WRC-1
may cause wireless interference. The WRC-1 antennas should never be covered in the rack while in
operation.
• Avoid interference from other electronic devices. Interference may be caused by nearby appliances such as
two-way radios, copy machines, printers, microwave ovens, and refrigerators.
• Minimize obstacles, especially large steel or metal objects, between the WRC-1 and wireless-connected
devices. The WRC-1 should not, for example, be placed in a location where a stage or riser is directly
between the unit and the wireless device.
If you are unfamiliar with setting up or using the MyMon app, please refer to the My Mon user guide.
1. Attach the supplied antennas to the WRC-1 unit. Do not force the connection, as antennas marked 2.4 GHz will fit
only the 2.4 GHz sockets and antennas marked 5 GHz will fit only the 5 GHz sockets.
2. Connect the AC cable and power up WRC-1.
3. If you want to use DLNA, connect the DLNA WPA Ethernet port (2) to any available LAN port (1) on the back of
the unit, using a short Cat 5e (or better) cable.
4. Connect any available WRC-1 LAN port (1) to the Ethernet port on the host computer. This must be the same port
used by the MyMon /LV1 network, not the SoundGrid network. Use Cat 5e (or better) cable.
5. Connect your MyMon Mobile device to the WRC-1 5G Wi-Fi network. Out-of-the-box WRC-1 Wi-Fi network is not
password protected. You can password protect your network using WRC-1 Management Software.
Important: The LV1 Ethernet port used for the MyMon network must not be the same Ethernet port used
by the SoundGrid network. Combining MyMon and SoundGrid Networks on the same LV’1 ethernet port
is not supported.
We are strongly advise that you use default settings, as these settings are compatible with almost all use cases.