Scribd
Upload
33 views17 pages

Ejemplo Diseño Y Simulación de Comparador de 1 Bit Usando Quartus Ii

The document describes the features of the DE0-Nano Development and Education Board including its FPGA chip, configuration and memory devices, input/output options, sensors, power supply, and connectivity. It contains details about the logic elements, embedded memory and multipliers of the FPGA as well as the board's buttons, switches, LEDs, ADC, clock system, and expansion headers.

Uploaded by

leo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
33 views17 pages

Ejemplo Diseño Y Simulación de Comparador de 1 Bit Usando Quartus Ii

The document describes the features of the DE0-Nano Development and Education Board including its FPGA chip, configuration and memory devices, input/output options, sensors, power supply, and connectivity. It contains details about the logic elements, embedded memory and multipliers of the FPGA as well as the board's buttons, switches, LEDs, ADC, clock system, and expansion headers.

Uploaded by

leo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 17

EJEMPLO DISEÑO Y SIMULACIÓN DE COMPARADOR DE 1 BIT USANDO QUARTUS II

https://www.terasic.com.tw/cgi-
bin/page/archive.pl?Language=English&CategoryNo=165&No=593&PartNo=2
DE0-Nano Development and Education Board
DE0-Nano Development and Education Board

Cyclone® IV EP4CE22F17C6N FPGA

 22,320 Logic elements (LEs)


 594 Embedded memory (Kbits)
 66 Embedded 18 x 18 multipliers
 4 General-purpose PLLs
 153 Maximum FPGA I/O pins

Configuration Status and Set-Up Elements

 On-board USB-Blaster circuit for programming


 FPGA Serial Configuration Device (EPCS)

Expansion Header

 Two 40-pin Headers (GPIOs) provides 72 3.3V I/O pins


 Two 5V power pins, two 3.3V power pins and four ground pins
 One 26-pin header provides 16 3.3V digital I/O pins and 8 analog input pins to
connect to analog sensors, etc

Memory Devices

 32MB SDRAM
 2Kb I2C EEPROM

General User Input/Output

 8 green LEDs
 2 debounced push-buttons
 4 dip switches

G-Sensor

 ADI ADXL345, 3-axis accelerometer with high resolution (13-bit)

A/D Converter

 NS ADC128S022, 8-Channel, 12-bit A/D Converter


 50 ksps to 200 ksps

Clock System

 On-board 50MHz clock oscillator

Power Supply

 USB Type mini-AB port (5V)


 Two DC 5V pins of the GPIO headers (5V)
 2-pin external power header (3.6-5.7V)

Connectivity

Connect D5M

 Connect with 5-megapixel CMOS Sensor (D5M)


SIMULACION

You might also like