Advanced installer’s parameters menu GB

UFH range “RF” or “Wired” LCD thermostat

External sensor
NTC type 10k Ω
at 25°C (ß = 3950)

How to accede it

In order to enter in the menu, go to the Comfort mode and maintain the (OK) key pressed during 10 seconds, the
following display must be appears:

Press 10 sec on the

- Once you entered in the menu, go to the parameter which you can change by using the keys (+) or (-).

- Once the parameter displayed, press the (OK) key to start to blink the value, then you can adjust it with (-) or (+) keys.
Press (OK) or wait few seconds to valid your adjustments.

- To leave the parameter menu, go to the parameter “End” and press the (OK) key.

Note:

You could reload one parameter to the default value by pressing in the same time the (-) or (+) keys when the
parameter value blinks.
 Parameters Installer’s Advanced Menu
number name Description of the parameter Factory value Other possibility

11 View of the measured values of the ambient sensor. “__._”

View of the measured values of the floor (external)

The following parameter is only available with the wired version

“bp” “hys”
14 reg Selection of regulation type
Proportional band 0,5°C Hysteresis
(PWM) (On/Off)
“10”
You could increase
Selection of the proportional band duration in minutes this value if the
15 Cy (cycle duration) Ideal value for all concrete floor have a
Water floors heating big inertia
application.
Adjustable “0” to
16 on Minimal starting time in minutes “002”
T cy/2

Adjustable “0” to
17 off Minimal resting time between 2 heating cycles in minutes “002”
T cy/2
Adjustable “1” to
Value of the proportional band in °C
Note:
“2.0” “6.0”
Ideal value for all A well insulated
18 bp If the value of proportional band is too big the system
Water floors heating
reactivity will be slower and could affect the steps of the house « 1.5°C»
program and the regulation. application. A not insulated
house « 4°C »
Adjustable “0” to
Compensating value of the regulation “14.0”
Increase this only
19 Cp This value will need to be modified only if the thermostat “00.0” value if the
is perturbed by the heating element. thermostat is too
Generally never the case with under floor heating. close to the heating
source.

20 rst All parameters will be reloaded with the factory value. Press on the (OK) key during few seconds.

29 End To exit the installer’s menu Press on the (OK) to exit.