Scribd
Upload
693 views

Openview - How To Connect Guide - June2020 PDF

To connect a satellite decoder: 1. Connect the LNB cable from the satellite dish to the decoder. 2. Connect the decoder to the TV using an RCA, AV mini jack, or HDMI cable, matching the cable colors to the port colors. 3. Connect the power cable from the decoder to a power source to turn it on.

Uploaded by

thea muller
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
693 views

Openview - How To Connect Guide - June2020 PDF

To connect a satellite decoder: 1. Connect the LNB cable from the satellite dish to the decoder. 2. Connect the decoder to the TV using an RCA, AV mini jack, or HDMI cable, matching the cable colors to the port colors. 3. Connect the power cable from the decoder to a power source to turn it on.

Uploaded by

thea muller
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

HOW TO CONNECT

If you already have a satellite dish and would like to install and
activate your decoder, please follow the following steps:

To connect your decoder to the satellite dish, you will need to connect the LNB cable from your satellite
dish to the LNB IN or DISH IN slot at the back of your decoder. There are three ways to connect your
decoder to your TV:

1 2 3
RCA Cable AV Mini Jack HDMI
If you are using an RCA cable If you are using an AV mini jack If you are using an HDMI cable, then
connect the cables to the back of cable, plug the single jack into plug it into the HDMI port on the
your decoder – matching the colours the back of your decoder. Then, back of your decoder and then plug
of the connectors to the colours of connect the other end of the cable the other end into an HDMI input
the ports (red to red, white to white to your TV. port on your TV.
and yellow to yellow).
Make sure you are plugging them You will then need to switch to the
relevant HDMI source/input channel
Then, connect the other end of the into the ports that are marked
on your television.
cable to your TV. Make sure you are INPUT. Match the colours of the
plugging them into the ports that are connectors to the colour of the
marked INPUT. Again, match the ports (red to red, white to white
colours of the connectors to the and yellow to yellow).
colour of the ports (red to red, white VIDEO AUDIO AUDIO VIDEO AUDIO AUDIO HDMI
IN IN (L) IN (R) IN IN (L) IN (R)
to white and yellow to yellow). If your TV does not have coloured
ports, then plug the connectors in
If your TV does not have coloured accordingly: yellow into VIDEO IN, CHANNEL
ports, then plug the connectors in
accordingly: yellow into VIDEO IN,
white into AUDIO IN (L) and red
into AUDIO IN (R) – if available. 100
white into AUDIO IN (L) and red into
AUDIO IN (R) – if available.

To power your decoder, you will need to connect the power cable to the decoder and connect it
to a power source. Your decoder should then switch on and start scanning.
Once scanning is complete you will see channel 100.
Your decoder is now ready to be activated.

You might also like