Solution Report For: Home My Test Bookmarks My Profile
Solution Report For: Home My Test Bookmarks My Profile
BUY PACKAGE
Q. No Question Status
NEWS
Q.1 A soil sample having liquid limit of 60% and plasticity index of 35 is classified as per
Ask an Expert plasticity chart as
a. CH
b. OH
c. MH
d. MI
Solution. 1
(a)
Solution. 2
(d)
Q.3 What is the most important condition to be satisfied for piping phenomenon to occur in
soils?
Solution. 3
(c)
Q.4 The vertical stress on a vertical line at a constant radial distance from the axis of a
vertical load in a soil mass
Solution. 4
(c)
Solution. 5
(c)
Q.6 For the development of passive state, the backfill of the retaining wall should be
subjected to
a. zero expansion
b. zero compression
c. maximum expansion
d. maximum compression
Solution. 6
(d)
Q.7 When water level rises to ground level from a great depth, the ultimate capacity of a
strip footing in sandy soils decreases approximately to
a. 30%
b. 50%
c. 70%
d. 100%
Solution. 7
(b)
Q.8 Thin wall samplers are those in which the wall thickness is less than
a. 1% of diameter
b. 2.5% of diameter
c. 5% of diameter
d. 7.5% of diameter
Solution. 8
(b)
If the specimen of this soil shrinks from a volume of 10 cm3 at liquid limit to 5.94 cm3
when oven dried, then the shrinkage ratio of the soil will be ____________.
Solution. 9
Q.10 The coefficient of permeability of a soil sample is found to be 1 × 10–3 cm/s at a void
ratio of 0.4. The permeability of same soil with same fluid at same temperature but at a
Solution. 10
Q.11 In a consolidation test, the load was changed from 50 kN/m2 to 100 kN/m2. The change
in void ratio was observed as 0.05 from an initial value of 0.7. The coefficient of volume
Solution. 11
Q.12 A unit volume of a mass of saturated soil is subjected to horizontal seepage. The
saturated unit weight is 22 kN/m3 and the hydraulic gradient is 0.3 The resultant body
force on the soil mass is _____________ kN.
Solution. 12
Q.13 The ratio of weight of hammer used in IS heavy compaction test to that of light
compaction test is ______________.
Solution. 13
Q.14 The maximum depth of an unsupported vertical cut that can be made in a saturated
clay with unit weight 20 kN/m3 and an unconfined compressive strength of 80 kN/m2 is
____________ m.
Solution. 14
8 (7.99 - 8.01)
the surface of sand deposit is estimated as 400 kN/m2. The water table is at a
significant depth. If water table rises to the depth of 2 m below the ground level, the
Solution. 15
Q.16 The value of bearing capacity factor NC for piles in clay, as per Skempton is
_____________.
Solution. 16
9 (8.99 - 9.01)
Q.17 A saturated soil sample has a volume of 23 cm3 at liquid limit. The shrinkage limit and
liquid limit are 18% and 45% respectively. The specific gravity of solids is 2.73. The
minimum volume that can be attained by soil is
a. 12.5 cc
b. 15.4 cc
c. 18.7 cc
d. 20 cc
Solution. 17
(b)
a. 1 and 2
b. 3 and 4
c. 1, 2 and 3
d. 1, 3 and 4
Solution. 18
(d)
Q.19 The water table in a deposit of sand 8 m thick, is at a depth of 3 m below the surface.
Above the water table, the sand is saturated with capillary water. The total and effective
a. 19.62, 19.62
b. 39.24, 39.24
c. 39.24, 19.62
d. 19.62, 39.24
Solution. 19
(d)
Q.20 Arrangement of two soils, soil A and soil B, is shown in figure. If the head loss in soil B
is 19 times the head loss in soil A and the permeability of soil A is 3 × 10–5 m/s, then
a. 1.48
b. 1.58
c. 1.75
d. 1.98
Solution. 20
(b)
Q.21 The results of two plate load tests performed on a given location with two circular
plates are given below:
1. Diameter = 750 mm, Settlement = 15 mm, Q = 150 kN
2. Diameter = 300 mm, Settlement = 15 mm, Q = 50 kN
Use Housel’s equation i.e. Q = Aq + Ps
A = Contact area
q = Bearing pressure beneath area A (constant)
P = Perimeter of footing
s = Perimeter shear (constant)
Determine the load (in kN) on circular footing 1.2 m diameter that will cause a
settlement of 15 mm.
a. 279.6
b. 402.18
c. 512.2
d. 558.8
Solution. 21
(a)
Q.22 The following data on consistency limits are available for two soils A and B :
The soil which is (i) more plastic and (ii) better foundation material, respectively are
a. A, B
b. B, A
c. A, A
d. B, B
Solution. 22
(d)
Solution. 23
(b)
Q.24 Pore pressure parameter A accounts for change in pore pressure due to change in
Solution. 24
(d)
Q.25 The dry unit weight of a sand sample in the loosest state is 13.34 kN/m3 and in the
densest state, it is 21.19 kN/m3. If the porosity and specific gravity of this sand are 33%
and 2.68 respectively, then the density index of the sand is ___________ %.
Solution. 25
Q.26 For the permeameter shown in figure, the pressure head at point marked A is
____________ m.
Solution. 26
Q.27 A layer of fully saturated soft clay is 6 m thick and lies under a newly constructed
building. The weight of sand overlying the clayey layer produces a pressure of 260
kN/m2 and the new construction increases the pressure by 100 kN/m2 both calculated
at the center of clay layer. If the water content of the clay layer is 40%, specific gravity
is 2.65 and compression index is 0.5, then the settlement of the foundation will be
____________ cm.
Solution. 27
Q.28 A dam is constructed on a soil with coefficient of permeability as 3 × 10–3 cm/s. The
flow net has 6 flow channels and 11 equipotential drops. If the head difference between
upstream and downstream end of the dam is 3.3 m, then the loss of water through
Solution. 28
Q.29 The effective shear strength parameters of a soil are 25 kPa and 30°. The soil mass is
in submerged condition. The shearing resistance on a plane at which total normal
stress is 328 kPa and pore water pressure is 114 kPa is ________________ kPa.
Solution. 29
Q.30 A cutting is to be made in clay for which the cohesion is 35 kN/m2 and Φ = 0°. The
density of soil is 20 kN/m3. The cutting has side slope of 1.5 to 1. Taylor’s stability
number for given conditions is 0.17. The depth of cut for a factor of safety of 1.5 is
___________ m.
Solution. 30
purely cohesive soil (c = 20 kN/m2). The net ultimate bearing capacity as per
Solution. 31
Q.32 A plate load test is conducted on a cohesionless soil with a test plate having width 60
cm and settlement of this plate is 12 cm obtained at the same load intensity as on the
foundation. A footing having a width of 2 m is to be constructed as foundation. The
settlement experienced by the footing will be ___________ cm.
Solution. 32
Q.33 A timber pile was driven by a drop hammer, weighing 30 kN, with a free fall of 1.2 m.
The average penetration of the last few blows was 5 mm. The safe capacity of the pile
according to Engineering News formula is _____________ kN.
Solution. 33