Scribd Logo
Upload

Welcome to Scribd!

  • 58 views

    Make & Take: Rockler Series Rockler

    Uploaded by

    cajemar

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Make & Take: Rockler Series Rockler

    Uploaded by

    cajemar
    58 views2 pages

    Original Title

    Screwdriver-handle-plan

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    58 views2 pages

    Make & Take: Rockler Series Rockler

    Uploaded by

    cajemar

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 2

    Rockler GET FROM ROCKLER

    Stock # Item

    Make & Take


    34890 4-in-1 Screwdriver
    Turning Kit
    48723, 48535, 49632
    Ergonomic Carbide
    Turning Tools

    Series 22134 Woodturners Multi-


    Roll Sanding Pack

    - Various hardwood species


    turning blanks

    - Epoxy or CA Glue Drying oil


    or Wipe on Finish

    Create a beautiful heirloom-quality tool


    with our 4-in-1 Screwdriver Turning Kit
    and your choice of select hardwoods.

    Wooden Handle Screwdriver www.rockler.com


    800-279-4441

    © 2019 Rockler Companies Inc.


    1. DRILL THE INSERT HOLE 2. MOUNT THE BLANK ON THE LATHE 3. TURN THE FERRULE TENON

    Drill a 3-3/4”-deep stepped hole for the Mount the blank on the lathe, using ei- Rough turn the blank round. Then turn a
    knurled insert. Use a 5/8”-dia. bit for the ther a drive center or a four-jaw chuck at 5/8” long tenon on the drilled end. The
    first 1-1/2” depth and a 1/2”-dia. bit for the headstock end, and a cone-style live diameter of the tenon must be the same
    the rest of the depth. center at the tailstock end. as the inside diameter of the ferrule.

    4. TURN THE HANDLE SHAPE 5. ATTACH THE FERRULE 6. INSTALL THE INSERT AND BIT

    Turn the final screwdriver shape. Sand it Apply epoxy to the tenon and drive the Epoxy the knurled insert in the handle.
    smooth and apply finish. Remove the han- ferrule over the tenon. Firmly seat the Drive the insert down flush with the end of
    dle from the lathe, cut off the waste on the ferrule on the tenon shoulder. the handle. Finally, slide the reversible bit
    headstock end, and touch up the finish. shaft into the knurled insert.

    2 © 2019 Rockler Companies Inc.

    You might also like