Scribd
Upload
110 views1 page

6.2.3 Interfacing The Zigbee Transceivers With The Arduino

This document describes how to interface ZigBee transceivers with Arduino boards for wireless communication. The ZigBee modules are connected to the Arduinos with the 3.3V and ground pins connected and the transmit pin of the ZigBee connected to the receive pin of the Arduino and vice versa.

Uploaded by

Raghu Raman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
110 views1 page

6.2.3 Interfacing The Zigbee Transceivers With The Arduino

This document describes how to interface ZigBee transceivers with Arduino boards for wireless communication. The ZigBee modules are connected to the Arduinos with the 3.3V and ground pins connected and the transmit pin of the ZigBee connected to the receive pin of the Arduino and vice versa.

Uploaded by

Raghu Raman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Figure 14: XCTU console screen illustrating the Xbee communication

6.2.3 Interfacing the ZigBee transceivers with the Arduino:

Once tested, the Xbee modules are connected to the Arduinos on both the EV side and the
control station side. The actual connections are as follows:

Connections on EV side

ZigBee Arduino

3.3 V 3.3 V

GND GND

Tx0 Din

Rx0 Dout

37

You might also like