Scribd
Upload
33 views

Project Progress Report Form 2

The project progress report discusses a music operated DJ lights and infrared remote control switch circuit created by two students, Mohan Mohinish Ram and Sufyaan Ali, under the supervision of Nauneet Menon. The circuit is fully functional and operates at 5 volts, turning the lights on and off via an infrared remote control. However, the remote control circuit occasionally malfunctions, causing transistors to burn out. Testing shows the infrared sensor circuit works at 5 volts with a 220 ohm current limiting resistor and only responds to a 35 kHz frequency infrared signal.

Uploaded by

mohan ram
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
33 views

Project Progress Report Form 2

The project progress report discusses a music operated DJ lights and infrared remote control switch circuit created by two students, Mohan Mohinish Ram and Sufyaan Ali, under the supervision of Nauneet Menon. The circuit is fully functional and operates at 5 volts, turning the lights on and off via an infrared remote control. However, the remote control circuit occasionally malfunctions, causing transistors to burn out. Testing shows the infrared sensor circuit works at 5 volts with a 220 ohm current limiting resistor and only responds to a 35 kHz frequency infrared signal.

Uploaded by

mohan ram
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Fiji National University

School of Electrical & Electronics Engineering

Project Progress Report Form

Unit Code: EEC405


Unit Title: ELECTRONICS PROJECT
Project Supervisor: NAUNEET MENON
Project Group Student 1 Name: MOHAN MOHINISH RAM
Members: Student 1 ID: 2019003115
Student 2 Name: SUFYAAN ALI
Student 2 ID: 2020001829

Project Title: MUSIC OPERATED DJ LIGHTS AND INFRARED REMOTE CONTROL SWITCH
CIRCUIT

Summary of Progress: CIRCUIT IS FULLY FUNCTIONAL


Second week and Currently the circuit is completed on the breadboard and is working as
expected the infrared remote control switch circuit does start malfunctioning from time to
time which causes the two transistors BC558 and BC548 to burn out.
The Circuit operates at 5 volts and can be turn on/off when ever needed with remote
control circuit.
The IR sensor circuit works at 5 volts with 220 Ω current limiting resister. The IR sensor
circuit only works with 35 kHz frequency.

1
Analysis and Testing (Simulation Results and Measurements)

2
3

You might also like