Scribd
Upload
121 views

Bar Based Problems

The document contains 9 problems related to determining stresses, strains, elongations, and modulus of elasticity for various bars and rods with different geometries and materials when subjected to axial tensile or compressive loads. The problems involve circular rods, stepped bars, tapered bars, and bars made of different materials like brass. Parameters that need to be calculated from the given information include stress, strain, elongation, safe stress, internal diameter, maximum and minimum stresses, forces necessary for equilibrium, and modulus of elasticity.

Uploaded by

Sri Maruti
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
121 views

Bar Based Problems

The document contains 9 problems related to determining stresses, strains, elongations, and modulus of elasticity for various bars and rods with different geometries and materials when subjected to axial tensile or compressive loads. The problems involve circular rods, stepped bars, tapered bars, and bars made of different materials like brass. Parameters that need to be calculated from the given information include stress, strain, elongation, safe stress, internal diameter, maximum and minimum stresses, forces necessary for equilibrium, and modulus of elasticity.

Uploaded by

Sri Maruti
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Assigment questions :

Problems on bars :-

1. A circular rod of 12mm diameter was tested for tension . the total elongation on a 300 mm
length was 0.22 mm under a tensile load of 17 KN.Find the value of E

2. A rod 150 cm long and diameter 2.0 cm is subjected to an axial pull of 20KN .If the modulus
of elasticity of the material of the rod is 2x 10 5 N/mm2 ; determine :

i. The stress
ii. The starin
iii. The elongation of the rod

3. Find the young’s modulus of a brass rod of diameter 25mm and of length 250 mm which is
subjected to a tensile load of 50 KN when the extension of the rod is equal to 0.3mm

4. The safe stress , for a hollow steel column which carries an axial load of 2.01x 10 3 KN is 125
MN/m2 . if the external diameter of the column is 30 cm, determine the internal diameter ?

5. A stepped bar shown in the fig is subjected to an axially applied compressive load od 35
KN .Find the maximum and minimum stresses produced

6. An axial pull of 35000N is acting on a bar consisting of three lengths as shown in fig . If the
young’s modulus = 2.1 x 10 5 N/mm2 , determine :
i. Stresses in each section end
ii. Total extension of the bar
7. A member ABCD is subjected to point loads P 1 ,P2 ,P3 and P4 as ahown in fig below Calculate
the force P2 necessary for equilibrium, if P1 =45 KN ,P3= 450 KN and P4 = 130 KN. Detremine
the total elongation of the member , assuming the modulus of elasticity to be 2.1 x
5 2
10 N/mm

Problems on uniformly tapering circular bars

8. A rod which tapers uniformlu from 40mm diameter to 20 mm diameter in a length of


400mm is subjected to an axial load of 5000 N. If E =2.1x 10 5 N/mm2 , find the extension of
the rod .

9. Find the modulus of elasticity for a rod,which tapers uniformly from 30mm to 15mm
diameter in alength of 350 mm .The ros is subjected to an axial load of 5.5 KN and extension
of the rod is 0.025 mm ?

You might also like