Scribd
Upload
51 views2 pages

Picture of The Mother Removed From The Chassis

This document provides instructions for troubleshooting a motherboard issue by locating the real time clock IC chip and setting a jumper to test if the system will start up. The jumper should be set to test a startup, the system should then be shut down and the jumper removed to see if the system works normally.

Uploaded by

Muhammad Ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
51 views2 pages

Picture of The Mother Removed From The Chassis

This document provides instructions for troubleshooting a motherboard issue by locating the real time clock IC chip and setting a jumper to test if the system will start up. The jumper should be set to test a startup, the system should then be shut down and the jumper removed to see if the system works normally.

Uploaded by

Muhammad Ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Picture of the mother removed from the chassis

Picture of the mother board without pci chassis removed.


Location of the Dallas Real Time clock IC

Detailed view with the location of the jumper.

Set the jumper (it is normally open) put power on the O2 and check if it will start-up.
Perform a normal shutdown and then remove power plugs and remove the jumper
again.
The system should work normally.

You might also like