Flexi Pole Kit Description: Installation With Remote Radio Heads
Uploaded by
Серега МазунинFlexi Pole Kit Description: Installation With Remote Radio Heads
Uploaded by
Серега МазунинFlexi Pole Kit (FPKA) description
This section describes the following hardware:
Flexi Pole Kit (FPKA) 471649A
Figure: Flexi Pole Kit (FPKA)
Flexi Pole Kit (FPKA) can be used with poles between 60 mm (2.4 in.) and 120 mm (4.7 in.) in diameter. The FPKA can
replace the VMPB Pole Mounting kit in installations where the pole diameter is less than 120 mm (4.7 in.).
The width of the fixing points is 184 mm (7.2 in) and 64 mm (2.5 in). There are fixing points on three sides of the FPKA.
The M10 screws should be tightened to 30 Nm (22.13 ft-lb) and the M8 screws to 20 Nm (14.75 ft-lb). The maximum
allowed weight on the FPKA is 160 kg (352.7 lbs). Two FPKAkits support two FMFAs, one on each side of the pole.
Each FMFA (plinth) can support a maximum of two 2U or 3U Flexi modules with casings, cables, and auxiliary boxes
(e.g. OVP). Note that for larger configurations it is recommended to use FPKC.
Installation with Remote Radio Heads
The FPKA has room for three Remote Radio Heads. It is possible to use three installation directions.
See Figure: FPKA with three Remote Radio Headsfor the FPKA installation with three Remote Radio Heads.
Figure: FPKA with three Remote Radio Heads
Installation with Flexi modules
The FPKA has room for a maximum of four 3U Flexi modules (12U total). Two modules (or casings) can be installed on
opposite sides of the FPKA. SeeFigure: FPKA with four 3U Flexi Modules for the FPKA installation with four 3U
modules.
