The Honeywell controls in the left hand column are recommended replacements for the

following products:

Motorised Valves
Honeywell
Control Danfoss Drayton Siemens Salus Tower Horstmann Sunvic Myson Sauter

V4043H1056 HP22 ZA5/679-2 CMV222 SPMV22 VAL22 F222 SZV22 MPE222 V222D
2 Port Valve 2MV 12

V4073H1039 HS3 MA1679-3 CMV322 SPMV32 VAL32 Z322XL SDV22 MPE322 B322D
3 Port Valve 2MP 11

Timers / Programmers
Honeywell Danfoss Drayton Siemens Salus Delta Horstmann Potterton Sunvic Myson Sauter
Control Dore
ST9100 TS715Si LP711 RWB27 EP100 TY-BOX H11XI EP5002 Select MEP1C T17
Time Switch
Compatibility Chart

817 107XL
ST9400C FP715Si LP722 RWB29 EP200 TY-BOX H27XL EP2002 Select MEP2C T27
Programmer 827 207XL

Wired & Wireless Room and Programmable Thermostats

Honeywell Danfoss Drayton Siemens Salus Delta Horstmann Why not change the
Control Dore timer/programmer as
well. Install a Sundial
Y6630D RETBRF Digistat RDH10RF RT30 D10RF HRT4-ZW RF² programmer on the
and DT92E Plus RX1 Plus 0RF
existing back plate and
the thermostat (room
DT90E and cylinder) will work
2 wire volt free connections mean the Honeywell DT90 digital
Wired straight out of the box
Thermostat thermostat will replace almost all other wired thermostats
— no need to wire an
additional relay box.
Don’t forget there are single day Honeywell programmable thermostats available as well

Honeywell Danfoss Drayton Siemens Salus Delta Horstmann Sunvic Myson

Control Dore
CM927 Wireless TP5000 Digistat 3 RDJ10RF RT500RF TY-BOX Thermoplus TLXRFP MPRTRF
Programmable
Thermostat SiRF RF3 610RF AS2

Don’t forget the Honeywell wiring guide app for smart phones and tablets is available from iTunes and the Google Play Store

*At the time of going to press, this compatibility data has been prepared using available
printed data from a range of manufacturers, please ensure that you check the Honeywell
fitting instructions, the Honeywell wiring guide against the existing wiring you encounter
carefully. If in doubt, please consult available technical resources both at Honeywell and if
necessary the manufacturer of the old control.

www.honeywelluk.com
EN3H-3129UK01R0912
 Honeywell offers a range of thermostats that provide a full range of modern features
and will ensure that users control their heating and hot water efficiently. This ensures that
comfort levels are maintained and heating and hot water is provided cost effectively.

Sundial RF² - Installation just got easier

These boxed set of controls feature combinations of a
wireless enabled timer; wireless thermostat(s) and a
wireless cylinder thermostat allowing a wide range of
installations.

DT90 Digital Thermostat

Automatic control of gas AND oil fired boilers,
electric AND underfloor heating
Ideal for zoning as part of a Sundial pack
Thermostat Information

Qualifies as a load compensator

Two wire, volt free connections - ideal for use
with combi boilers
WILL REPLACE ALMOST ANY OLD
THERMOSTAT EASILY
Eco button & Off button that adjusts the set
point at the touch of a button are added energy
saving features for customers
NO NEED to wire extra receivers

Fitting the timer onto an existing backplate will AVOID

THE NEED to comply with Building Regulations Part P

Commissioning is easy, the wireless products are

pre-bound and will work straight out of the box

Service Interval reminder including space for your

telephone number

Ideal for adding a Ideal for adding a

Pack room thermostat to Pack room thermostat to an
combi boilers and existing Sundial
1 single heating zones 2 system that has stored
Programmable Thermostats hot water and a DHW
- adding another level of control thermostat

Combine time and temperature together to give Ideal for adding a Ideal for adding a hot
sophisticated levels of comfort and control in all room thermostat and water timer and
Pack cylinder thermostat Pack
domestic heating situations. cylinder thermostat to
CM900 - the best choice you can make 3 to new and existing
Sundial systems, or 4 new and existing
Sundial systems, or
upgrading a gravity upgrading a gravity hot
Battery powered & VOLT FREE switching hot water system water system
allows you to work with ALL voltages between
24 & 230 volts Ideal for providing 2
Pack heating zones – THERE IS A SUNDIAL RF²
Burner on symbol, FAULT DIAGNOSTICS & enables compliance PACK FOR ALL DOMESTIC
SERVICE INTERVAL reminders to assist you in
maintenance 5 to latest Building
Regulations Part L HEATING SYSTEM
2010 REQUIREMENTS
Programmed settings are saved even when
power is lost - avoiding call backs

www.honeywelluk.com
EN3H-3129UK01R0912