Scribd
Upload
41 views2 pages

Purlin Design-Rev1

The document describes the design of purlins for a roof with the following criteria: 1. The wind load is 167.04 N/m and dead loads include 125.73 N/m from roofing and 27 N/m from the purlins themselves. 2. The normal bending moment from wind and dead loads is calculated to be 119.13 N-m and the tangential moment is 24.15 N-m. 3. Checking for a compact section shows the purlins can resist bending using a yield strength of 141 MPa. The actual bending stress is calculated to be 110.53 MPa, within the allowable limit.

Uploaded by

Joshua Espanto Moren
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
41 views2 pages

Purlin Design-Rev1

The document describes the design of purlins for a roof with the following criteria: 1. The wind load is 167.04 N/m and dead loads include 125.73 N/m from roofing and 27 N/m from the purlins themselves. 2. The normal bending moment from wind and dead loads is calculated to be 119.13 N-m and the tangential moment is 24.15 N-m. 3. Checking for a compact section shows the purlins can resist bending using a yield strength of 141 MPa. The actual bending stress is calculated to be 110.53 MPa, within the allowable limit.

Uploaded by

Joshua Espanto Moren
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 2

DESIGN OF PURLINS:

I. DESIGN CRITERIA:
A. WIND LOAD:
Pn = 506.17 N/m2 506.17x.33= 167.04 N/m
B. DEAD LOADS:
Weight of Roofing 381 N/m2 381x.33= 125.73 N/m
Weight of Purlins 27 N/m
truss spacing 1.73 m
angle 25 degrees
spacing of purlins 0.33
Fy 235 Mpa
II. DESIGN MOMENT:
A. WIND LOAD:

M = wL2/8 62.49 N-m (Normal Moment)

B. DEAD LOADS:

M = wL2/8 57.14 N-m (Gravity Moment)

Normal Moment due to Dead loads:

Mn = M cos 25o 56.64 N-m (Normal Moment)


Mt = M sin 25o 24.15 N-m (Tangential Moment)

TOTAL NORMAL MOMENT = 119.13 N-m


TANGENTIAL MOMENT = 24.15 N-m

III. REQUIRED SECTION:

a. check for compact section:

bf/2 tf = 7.81 > 3.41


52.2/square of Fy 3.41

therefore use Fb = 0.6 Fy = 141 Mpa

b. Actual fb :

fb = Mn/Sx + Mt / Sy

= 110.53 Mpa < 141 Mpa (safe for bending)

IV. CHECK FOR DEFLECTION:

Actula Deflection = 5wL4/384EI 1.53 mm


Allowable Deflection = L/240 7.21 mm

You might also like